the width removed will be approximately 10 feet and, so as not to damage perfect original coving, i am planning on leaving approx 20 inches below the ceiling line. i was supposing i would then simply put a long 4x2, supported at each side, to make the bottom of the "arch" (which will be square) but will i need a lintel (non load bearing) to ensure that this stays square. I am assuming I need something to effectively prevent the top of the 4x2 vertical studs from falling down on themselves,as they will needto remain in situ because I am leaving the top part of the wall.
2006-08-17
09:50:15
·
10 answers
·
asked by
AnthonyM
1
in
Do It Yourself (DIY)