Mazda

i have a series 1 rx7 standard 12a i just want to put a small turbo in it. i was thinking of a t25 turbo whats the average cost of that. what else do i need to convert it like do i need to change the brakes radiator etc?

2007-09-14 19:24:22 · 1 answers · asked by Anonymous

i've been looking for a cheap car. cheap but that will last me a few years. My friend offered to sell me her mazda protege 1999. it's got 120,000. she would sell it for 2,000. it's got a new alternatoer but will soon need new struts.
I've always had hondas or toyotas. are mazdas good cars? 120,000 sounds like a lot ut my other cars lived well past that. could the mazda do the same.

2007-09-13 03:58:39 · 8 answers · asked by Anonymous

2007-09-09 11:31:33 · 1 answers · asked by kyle d 5

my 83 rx7 runs sluggish in lower rpm range.It is fine when the rpms come up over 3500 but it just seems to hesitate a bit when starting out.Plugs,timimng, air cleaner and all vacuum hoses are good and working fine.Anyone wanna try this one?

2007-09-09 00:29:48 · 5 answers · asked by jpm7481 1

can you get a title from just a bill of sale and the approval of the previous owner. Because the owner of the car lost the title but he gave me a bill of sale and hes too busy to got to the dmv.

2007-09-08 05:39:31 · 5 answers · asked by jay d 1

2007-09-05 12:23:41 · 4 answers · asked by A-Will 1

I'v never adjusted valves before so i just need some advice in doing so.

2007-09-05 00:27:37 · 3 answers · asked by Anonymous

2007-09-03 09:55:59 · 9 answers · asked by reedrarjms 1

2007-09-02 23:40:08 · 6 answers · asked by D.K. Vasilis 1

my q is:
what are some of the mose cost effective way to increase my lower range rpm's. [under 3,000+ rpm]
do throttle body spacers help?
i already have a cold air intake. that helped allot.
what i roll in is a 2000 mazda protege. [aka 323]
and do heat shields help as well. i rele need to know.
[1.6L auto]

2007-09-02 14:53:54 · 5 answers · asked by pacman1853 2

We have a 2000 protege LX, now the rear passenser side foot well are full of water. I think the drain hose is clogged and the mechanics said the drain hose is missing. The drain hose for the evaporator. I can't seem to find the drain hose. I saw a little black hole under the hood below the two lines goes into the ac.
The mazda dealership said the hose costs $31 and labor $400. I hope I can do it myself since I don't think it's that hard. Do I have to lift the car up to find the hose or to replace it? And where is it?

Also, I know it's special for protege, but why would the water coming in from the carpet beneath the front passenger seat instead of the firewall?

Thanks

Josh

2007-09-02 10:06:55 · 2 answers · asked by Anonymous

for tork specs on a mazda b2000 1985 head boltz

2007-09-01 17:47:40 · 5 answers · asked by sunnydays 4

The car has 67k miles on it, I've always used synthetic oil. No warranty anymore. Here's a question. All of a sudden recently, I've noticed that when I accelerate, and the AC is on, the car makes a weezing, whistling noise, in the low gears. I can't really hear it in the high gears, maybe because I'm going fast enough to block out the noise. What could that be? And on top of that, when the car is in drive, and I come to a full stop, like at a light, the car viberates, and this....tut tut tut tut noise is coming from the right side of the car by the gulf department. Kind of like a household spinning fan, souds kind of like a cruiser motercycle idiling....you know? just not as extereme, any ideas?

2007-09-01 16:38:47 · 4 answers · asked by Anonymous

I put on a CAI and I was told to reset my ECU so the car can calibrate for the Air Management System. I need to know how to actually do the resetting and how long does it usually take to recalibrate the ECU once I reset it

2007-09-01 09:06:33 · 2 answers · asked by Anonymous

I have an RX8 which I absolutely love, only had it a couple of months but on websites it says main fault is 'engine flooding', and never switch it off after short journeys. I am beginning to worry, and if I ever have to move my car off the drive because I'm parked behind my husband I take it for a little drive instead of just moving it onto the road. Am I worrying un-necessarily?

2007-08-31 21:52:18 · 5 answers · asked by Heather B 2

I don't want to pay top price (like from Mazda). have checked around but cannot seem to find beige (or taupe), only black, red or silver. Any suggestions?

2007-08-31 14:53:40 · 2 answers · asked by Loraie M 1

I have a Mazda Capella 2001 and over these past few months this has been happening to my car while I'm driving. I took it to the garage not so long ago for a service and asked my mechanic to check it out, they gave it a full transmission fluid change and said they didn't notice anything wrong with it. The same problem is still happening. Any takers for this question? Please give me several options besides your transmission is stuffed, get a new one. Thanks.

2007-08-31 13:35:34 · 4 answers · asked by flavar07 1

The key will turn part way in the lock, however, the inside lock is stuck in the middle position, and I can not move it up or down. How do I get the door open? I have crawled in from the passenger side, and tried to push the lock while pulling the door handle, to no avail. Good advise only please.....

2007-08-30 07:28:16 · 5 answers · asked by usacherie 2

I am not sure but , I dont know if the reason of my check Engine light is the reguler gas I used in mazda 626 . I didnt know this but now that I am looking at the title it says Fuel---- Gasolin:(

does it mean I was not suppose to use other fuel than gasoline?

is it gona damage the car or the engine ?
I really don't know wat has gone wrong with it ..
:(

2007-08-29 20:46:10 · 7 answers · asked by Anonymous

I have also just had the timing belt replaced, and have had some other minor things repaired. Since picking it up from the mechanic's, it's been overheating - the heat gauge passes the halfway mark, and sometimes goes close to the top of the gauge. Why would it be overheating? Why more now than before? Could be the radiator or a leak in the cooling system?

2007-08-29 06:00:15 · 11 answers · asked by Anonymous

is this a hard job and $$ to have a shop do it.. I am somewhat mechanically inclined..what does it entail??

2007-08-28 13:21:13 · 6 answers · asked by TEXAS 2

2007-08-28 05:45:22 · 3 answers · asked by Matrix 1

2007-08-27 21:40:46 · 3 answers · asked by David J 1

I have a 1998 Mazda 4 Cylinder engine. It is losing oil pressure, so instead of buying a new car, I would like to replace the engine. So my question to you is how much would a used low mileage Mazda 626 engine be?? Anyone know a good site or place close to Chicago IL to get them at?

2007-08-27 14:35:39 · 4 answers · asked by RejecT 2

Ok i have to hold the hi beam switch towards me to get hi beams on my running lights work directionals work wipers work regular headlights dont i have to use hi beams but i have to also hold the switch towards me im thinking it could possible be a wire short any help would be appreciated.

2007-08-27 10:52:21 · 2 answers · asked by cyph3r_tr1ck_ryd3r 1

rotary or wenkled engine

2007-08-25 20:04:49 · 4 answers · asked by apend_jr 1

My 1994 Mazda Miata has always started with no problems until this morning. It started for a brief second and promptliy dies. Not a sputtering die but an instant die situation.

Battery and lights work fine
There is spark from the coil
Gas tank is full

Any ideas?

2007-08-19 12:52:55 · 9 answers · asked by duffasbutt 1

my carb is nameless, i cant find it.. i need to look up some info.

2007-08-19 11:38:57 · 2 answers · asked by violentchord 1

mazda B3 carb, 1990

2007-08-19 02:25:07 · 2 answers · asked by gdmartija 1

if i have hinson's engine swap kit and i have the Ls7 engine is that all i need to complete the swap or do i need to get other things? I read somewhere that hinson's won't work for some reason...

2007-08-17 11:44:59 · 1 answers · asked by Lanke 2