Dodge

2007-03-29 17:14:36 · 6 answers · asked by Brandon D 1

Will 16" rims clear the calipers on an '03 Dodge Ram 2500 4wd? Factory are 17".

2007-03-29 07:42:26 · 6 answers · asked by skinnee440 1

i want to know where to get the conversion kit and if i will need to do anything with the injection computer. also where can i get the 6 cyl...if not able to do the swap where can i get a new 4 cyl for it.

2007-03-29 06:23:55 · 6 answers · asked by luckymois 1

2007-03-28 22:17:49 · 10 answers · asked by kamasutraboy79 1

How much would it cost to replace by way of scrap yard? It has overdrive ( 3.6 V6) Any suggestions please.

2007-03-28 17:48:02 · 4 answers · asked by dogloverdi 6

2007-03-28 17:31:49 · 5 answers · asked by JON S 1

Basically every time i hit a little bump in the road of ANYTHING small. the front of the truck makes this horrible squeeky sound like and it sounds like its bouncing up and down. I was told before that i need new shocks, but not because of the squeeky sound, they didnt hear any squeeks. it was just someone looking under my truck at my front wheels. Is that what i need? New shocks? and will that stop the squeeking? it sounds really retarded and feel like im driving like a beat down box. lol . thanks for any info. anyone also know if i bought them off ebay. like 200 bucks. how much someone usually charges for install? thanks

2007-03-28 17:11:01 · 13 answers · asked by scion_xb_girly 3

why my car, an intrepid 99' 2.7, is burning the engine oil so fast ??? it has 110 K,

2007-03-28 16:21:00 · 7 answers · asked by fabian l 3

2007-03-28 14:11:01 · 3 answers · asked by kjjarvis6814@sbcglobal.net 1

How do I remove the fuel pump and how do I install it?

2007-03-28 13:06:31 · 3 answers · asked by Jimi B 1

Right by the transmission dipstick is a sensor. It is a sensor. And it is leaking trans. fluid. This "PLASTIC" sensor is "COMPLETELY ROUND". no socket can go onto it. It spins 360 degrees but wont spin out. Ive tried pulling it straight to but with no luck. any one know how to get it out??

2007-03-28 12:03:30 · 3 answers · asked by Anonymous

If it were fuel injected wouldn't it be clearly marked someplace on the vehicle?

2007-03-28 11:54:53 · 4 answers · asked by sarah c 1

2007-03-28 11:36:39 · 5 answers · asked by plz answer 1

2007-03-28 08:59:30 · 6 answers · asked by jordensnonna 1

is their a way to remove the side spotlights and plug the holes?

2007-03-28 00:27:03 · 7 answers · asked by emanon1999 3

WHAT CAN I DO TO MODIFY MY TRUCK AND NOT VOID MY WARRANTY? LIFT EXHAUST? IF I CAN DO IT DOES IT HAVE TO BE DONE AT THE DEALERSHIP?

2007-03-27 21:15:52 · 6 answers · asked by gyro 3

Is there anyone out there who makes a kit or package or something to convert the new chargers into coupes?

2007-03-27 16:25:42 · 2 answers · asked by Anonymous

My air works great riding down the road. But if i stop and idle for 15 seconds it blows hot air. It is NOT the amount of freon, I had it checked, and there is no trash built up in the freon radiator.

2007-03-27 15:35:19 · 11 answers · asked by careercollegestudent69 4

2007-03-27 13:47:29 · 6 answers · asked by tony 1

2002 Dodge Ram 2500 Cummins not high-output

2007-03-27 10:58:35 · 9 answers · asked by CJ A 1

Is there a special socket/wrench I have to get to take the filter off,or tighten it up

2007-03-27 05:09:54 · 5 answers · asked by robert v 1

2007-03-27 04:41:12 · 3 answers · asked by Anonymous

it heats up too quickly, ive already changed the thermostat, and the temp. sensor, and the cooling fan works fine .it doesnt heat up as quickly, but it still heats way too much , eventually. its a dodge neon 98'. and i just bought a new radiator cap, what else can be the prob.?

2007-03-27 04:31:57 · 11 answers · asked by Anonymous

Irealize studs will need to go to 9/16 . Are adapters safe?

2007-03-27 02:11:41 · 2 answers · asked by kain g 1

...the Front of Van. It only has 19,000 Miles on it and "Creaks" like a Door Opening...Coming from front end even when van is off, because I got out of van and it Creaked "after" it was shut off. This JUST STARTED and It does it all the time when Driving (like a spring needs oiling), It does it when turning the wheels...It does it when stopping (as the front end dives down), and again as the Front-End comes up when I press the gas to go from stopped position (stop signs, red lights, etc.). I just had a Full service oil change 200 miles ago and it still creaks!! and Remember, it only has 19,000 miles on it. I take Great Care of this Van. And Under the Extended Warrenty (7yrs/70,000), I would have to pay the First $100.00 to check it out at the Dodge Dealer. So, does anyone know what is causing this "CREAKING SOUND" in Front-End of a 2003 Dodge Grand Caravan.!!! How do I Eliminate this? It is very Annoying!!! Please Help?---RON in Michigan. Thank You All.

2007-03-26 18:53:32 · 5 answers · asked by Anonymous

I have a 2005 doge neon sxt, and the problem is i took it to walmart to get oil and injectors cleaned. They forgot a hose back on the master cylinder and this has cause the brakes to be extremely hard to stop the car. In other words I have to press the brake pedal hard to stop the car. I have taken it back to walmart and they have shown me where the hose is missing (their fault) but they don't know where it goes to. Please help I cannot figure it out and can not find a diagram that shows where it (the hose go to) it is the hose from the master cylinder to somewhere.

2007-03-26 18:51:21 · 2 answers · asked by torry r 1

I'm looking at a 2003 Dodge Ram 1500 at a lot in town. It is a Quad Cab with the 4.7l V8 engine. Anyone know what the tow rating is?

2007-03-26 17:38:45 · 7 answers · asked by nitestryder2169 1

How do i also check the timing belt specification on this car, are there designated point where the belt suppose to be fitted.

2007-03-26 17:07:28 · 5 answers · asked by Rambo 1

2007-03-26 15:51:47 · 1 answers · asked by Anonymous

2007-03-26 14:36:38 · 5 answers · asked by aBIGgurl2ENVY 2