English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Chevrolet

[Selected]: All categories Cars & Transportation Car Makes Chevrolet

is there anything to prolong one from going out on a chevy?

2007-02-25 04:21:33 · 11 answers · asked by ozfern187 1

I am interested in putting a power chip on my 1/2 ton 4x4 chevrolet silverado. What is the best chip to put on it and about how much does it cost?

2007-02-25 02:52:17 · 1 answers · asked by iliveforfridaynightlights 1

99 malibu sometimes when you go to crank the car it will start and immediately cuts off,theft system lite is blinking and until it stops blinking it wont crank,,,,now what do i do..can a hot wire be ran to the fuel pump to momentarily overide the theft system to start the car can some wires be cut and bypass the system to stop this from happening, i just want the thing to crank and go....thankyou...

2007-02-25 01:20:00 · 5 answers · asked by Anonymous

2007-02-24 16:27:48 · 15 answers · asked by yolandanbrown 1

its just a small basic 8 grand tach, goin on a 75 chevy truck,350 HEI

2007-02-24 15:25:42 · 6 answers · asked by wheels47012 3

i was in a accident. my driver door is badly bent.the wheel should be be straight is slightly turned to the left going out. my dad took the wheel off 2 determine the axle is not broken. the steel arm is bent. he said he would have to try to straighten it back out. but he said its steel its going to be real hard to bend straight. please tell me its fixable.

2007-02-24 14:56:56 · 9 answers · asked by tracie e 2

2007-02-24 14:09:29 · 2 answers · asked by drunk_luther69 1

we recently got my truck running, my friends dad got it in time and it runs fine but the idle adujstment on the carb is either high or too low. I think he turned it this far to compensate for being a couple teeth off. check it out, what do you think? Its got a high rise intake and 4:10's I need to be sure im gettin the most MPG I can. http://i114.photobucket.com/albums/n272/hunterman09/topviewofdistrib.jpg

2007-02-24 12:37:26 · 8 answers · asked by wheels47012 3

its an automatic transmission. does the level have to be checked with the engine idling or turned off?

2007-02-24 12:18:43 · 4 answers · asked by Hector L 2

ok theres obviously people on here that didnt get my last question about this, I asked how can I tell if my truck has a cam, I meant a bigger cam. IT HAS A CAM IN IT, but how can I tell if its a bigger one. idk that it matters but I got duals with broke in glass packs, 75 chevy truck 350

2007-02-24 11:52:48 · 14 answers · asked by wheels47012 3

Looking for suggestions. Thank you

2007-02-24 09:33:24 · 6 answers · asked by tom7574 1

I have checked Batt it is fully charged.,New Batt and clean post,I did find # 2 plug Wires loose at coil pack this car V 6.

2007-02-24 09:30:18 · 3 answers · asked by section hand 6

I can rotate the pump housing slightly but it won't move forwards. I'm scared to beat on it.

2007-02-24 08:41:38 · 5 answers · asked by spyder1242000 1

1985 chevy suburban,350 v8

2007-02-24 07:57:30 · 8 answers · asked by david r 1

2007-02-24 07:48:37 · 4 answers · asked by b.radeckels 1

2007-02-24 07:11:02 · 4 answers · asked by Ezz 6

I was playin fast and furious tokyo drift, and had a 70 chevelle maxed out at 700 horse and 750 tourqe with a 454. (the tourqe and horse may be backwards) but anyway if it is possilbe in real life to have that much, if u barley touched the gas would it burnout? and if you stomped it what would happen?

2007-02-24 05:26:39 · 8 answers · asked by wheels47012 3

it wont turn over. it dont make any noise. it just wont start

2007-02-24 05:14:53 · 6 answers · asked by drunk_luther69 1

2007-02-24 02:57:18 · 4 answers · asked by Jay and Meredith b 1

so far problems encountered:
- motor need to be redone
- transmission starting to 'jump'
- altenator acting up; suspect power steering pump is leaking and fluid is going up on belt...

What problems have people had with it.

2007-02-24 02:42:20 · 3 answers · asked by redglory 5

the fuses are all good, the break lights work,the blinkers work EXCEPT when i hit the breaks then if im turning right the left blinker blinks and viceverse, no tail lights at all,the bulbs are all good too,i undone the trailer lights and still the same, where do i look next?

2007-02-24 02:39:21 · 6 answers · asked by Anonymous

2007-02-24 02:20:10 · 8 answers · asked by Jay and Meredith b 1

I am having trouble with my Right Rear tailLights... I have been told by several people, I may have a bad Panel, or a bad ground... The blinker blinks fast, tail light is dim... Does anyone have any suggestions???

2007-02-24 01:39:42 · 4 answers · asked by Alan H 1

I recently changed a head and got a new carb for my truck, now most of you out there(that mes with old vehicles) know what a 350 sounds like with straight pipes and fully broke in glass packs, it was loud, now that I changed tht head and got a new carb its quieter? whys that? 75 chevy truck

2007-02-23 17:07:45 · 3 answers · asked by wheels47012 3

Which car you like better between a Chevy Chevette or a Chevy Citation? I personally like the Chevette better cause it's RWD and it's easier to fix and they're cuter looking cars.

2007-02-23 14:26:12 · 14 answers · asked by Fell In Love 7

I want to find out how hard it will be to make a Chey S10 straight4 standard 5 speed to an automatic.

2007-02-23 13:25:06 · 11 answers · asked by jasmine42000 2

They sold me the car for almost 14,000 w/ the fees its 16,000. i put 2,000 down payment. I looked at the prices and by the time i pay it in 6 yrs it would end up about 25,000 i would end up paying total. I'm supposed to pay $332 a month. If I was to pay more than $332 a month will I still end up paying up to $25,000 in 6 yrs? I spoke w/ the salesman and he said the more I send every month the less I would end up paying in 6 yrs so it wouldnt be $25,000. I feel like they ripped me off. What do you think? This is my first time purchasing a car which I need to pay monthly. Any comments/suggestions?

2007-02-23 10:45:00 · 6 answers · asked by Anonymous

...how the lobe separation angle affects the performance of a cam?

2007-02-23 09:23:08 · 7 answers · asked by m k 5

fedest.com, questions and answers