Motorcycles (Cars & Transportation) - June 2006

My car got stolen and Im lookin for a cheap motorcycle to fill the gap for my last two years of school. I was wondering what would be a good bike to look into. Which one has cheap parts, and even used are known for being "turn key" meaning I dont have to do anything but turn the key and ride. I suppose i'll have this a while so id kinda like it to be respectable. under 2000? Id like to stay around 1000 but.. any suggestions on bikes? ratings? consumer feedback?

2006-06-25 17:23:52 · 7 answers · asked by red_samurai_dragon 3

0 ⤊

carb jetting?

79 kz650. I want to put pod air filters on it. what main jets should i use (stock 97.5) thanks

2006-06-25 17:04:33 · 5 answers · asked by rs91350 2

0 ⤊

I'm looking for a Yamaha Vmax 1200 motorcycle, ideally in WI, any ideas where 2 look besides Ebay?No Dealers.

2006-06-25 16:50:01 · 4 answers · asked by frank t 1

0 ⤊

how can i make my 2 stroke pocket bike go faster without spending to much?

2006-06-25 16:19:58 · 7 answers · asked by wickedinsanerocker333 1

0 ⤊

What do you think?

Does anyone else think that putting faux fur on your motorcycle is freakin gay?

2006-06-25 15:00:57 · 20 answers · asked by zena1129 4

2 ⤊

How do you clean a motorcycle gas tank of gunk and rust from sitting empty for too long?

I did put stabilizer in it at one time but I emptied it and left it that way now.......its gunky

2006-06-25 13:24:23 · 7 answers · asked by billybb17 1

0 ⤊

I am makeing a after market exhuast from my stock one any tips?

the bike is a 2005 kawasaki z750s ok here is what I have done so far I cut 6 inchs off the can to make it shorter and more sportyer looking I took out all the guts till just the alloy shell was left took it off tac welded and peice of 2 in stainless stell pipe to the inside and then but a baffle in which I turned around so the fins dont catch as much flow which makes it louder ( the louder the better) but now I am going to take it apart and weld caps to the front and back of the baffle so all the air goes into the baffle and not around the outside. I dont think I have enough back presure but the bike runs fine othere then in higher r's it doesnt seam to pick up as quick ( i know a re map is needed) as I left off the gas it gets that popping sound like older trucks do as they go down over a hill if you know what I mean so if any one can give me tips on what I can do to improve this experiment I would appericate it and if you wanna chat message me

2006-06-25 12:14:04 · 4 answers · asked by bob : 1

6 ⤊

how can I look good on a motorcycle?

2006-06-25 12:03:52 · 20 answers · asked by ashb1994@sbcglobal.net 2

0 ⤊

2001 Kawasaki radiator cap?

Where is my radiator cap located
I have looked the bike up and down
Is it located under the seat
I haven't looked there yet??
It's a 2001 Kawasaki Vulcan 800A7

The Bike is
FOR SALE
Under 3,500 original miles
$4,000.00
http://www.aroostook-county-ubm.com/phy/clim/76660/Picture-bor94690.jpg

2006-06-25 11:57:39 · 1 answers · asked by Vulcan 1 5

0 ⤊

how do I check the charging system on my 1980 honda 750 motorcycle?

2006-06-25 11:24:56 · 4 answers · asked by Sunny 1

0 ⤊

why are my valves are hitting my piston?

the valves only hit my piston when there is a quick pull on the throttle and sometimes when using the kick start but under normal riding conditions or even if I'm going fast they don't meet at all...the problem started when we installed high compression piston and lengthened the duration on the cams..the piston has been modified several times to put deeper grooves so that the valves can't reach the piston and all though there is a difference they still do hit each other

2006-06-25 10:57:42 · 7 answers · asked by Anonymous

3 ⤊

i have just aquired a honda melody 1982 scooter 50cc.Can anyone help where i can buy a manual for this machine

its a two stroke engine but not sure the amount of oil and fuel to be mixed or can i buy this fuel already mixed. Sorry but never had a scooter so its new to me

2006-06-25 08:28:35 · 4 answers · asked by ? 1

1 ⤊

Motorcycle question. Does any one know how the electrical system works on a motorcycle?

Does any one know how the electrical system works on a motorcycle? I am familiar with the electrical system on an automobile using an alternator. I am having a problem getting a spark at the plug. Gaps on the plug are correct. I looked at the coil and it only seems to have “one side to it” unlike a car with two sides to the coil. Can anyone help me out in trouble shooting a spark plug with no spark? Thanks in advance for your help

2006-06-25 07:41:43 · 2 answers · asked by Tony 1

0 ⤊

does anyone know the starter assembly for a 1982 yahama virago motorcycle or where to find a detailed picture?

2006-06-25 07:34:08 · 3 answers · asked by chelly 2

1 ⤊

4 cylinder motorcycle that only runs on 3. ran fine untill spark plug wires got crossed. what happened?

Mechanic working in bike crossed spark plug wires and bike wouldnt start. Wires were correctly placed, and bike ran fine for a week. Now, ony cylinder is lost, only runs on three. Rough running, and stalling. Bike has 37,000 miles and is a "97 Honda Nighthawk 750. Could it be a coil or a spark plug?
Thanks in advance.

2006-06-25 07:21:55 · 7 answers · asked by tercera100 1

Motorcycles - June 2006