English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Nissan

[Selected]: All categories Cars & Transportation Car Makes Nissan

Not the SE-R Spec-V, just the SE-R?

2007-11-11 12:19:03 · 4 answers · asked by Anonymous

All other dash lights appear to be working fine. I looked at the fuse box and it doesn't appear there is a dedicated fuse just for the clock. Could it be a fuse?

2007-11-11 10:32:47 · 2 answers · asked by rholtke 1

The car is a little bit slipery on the upshift, is that a sign for the transmission to be changed or hopefully only its oil....what are the signs if the transmission needs to be changed? The car has done only 67,000miles and its a production of 1995...if the oil needs to be changed every 50,000 as i read before then i am hoping the transmission is still ok ....

2007-11-11 07:14:46 · 6 answers · asked by Anonymous

follow the link for a picture:

http://i108.photobucket.com/albums/n26/ro903/mufflers.jpg

2007-11-11 06:09:54 · 1 answers · asked by KaaM 1

pros and cons.

2007-11-11 04:00:44 · 6 answers · asked by Anonymous

the bolt on the starter of my 06 nissan sentra loosened up considerably,such that a terrible noise is created when i start the car,i was able to tighten the bolt and the noise went out,should i tell the dealership that i actually tightened the bolt? would they still look at the problem if i did?

2007-11-10 17:53:31 · 4 answers · asked by jcns 2

My neighbor and I have been trying to get his truck started. It's EFI Throttle Body. We've proven ignition and timing are good. The truck will start and run as long as you add fuel in the throat of the Throttle Body (TB). Thought the pump was bad, checked fuel pressure, GOOD. Fuel filter, Not Clogged.

We rebuilt the TB with all new gaskets and cleaned all passages. Removed the fuel injectors and opened them electronically and blasted carb cleaner through them.

Checked ALL fuses and the relay - All OK. Apparently the injectors are not being commanded to open. I figure it might be a bad sensor or (worst case) bad computer (ECU)

IF YOU HAVE EXPERIENCE OR SPECIFIC KNOWLEDGE, please lend me your assistance. It will be most appreciated.

Thanks.

2007-11-10 12:44:22 · 2 answers · asked by tercir2006 7

After the 350z takes off with auto trans, and you used the manual shift control throught the gears to red line, will it run as fast as the manual tranmission taken to red line through the gears? What is the advanatage of if any, would a manual trans have over the auto with shift control? Thanks

2007-11-10 10:38:33 · 3 answers · asked by Anonymous

i have a 2006 nissan sentra. its black with 16 inch rims. i want new rims but cant decide if i really want them only to get them and regret getting them. my tires are almost bald now. i was going to replace my factory rims and tires with aftermarket 17 inch black rims with chrome lip instead of getting the OEM tires back and keeping my factory rims. what should i do or any advice?

2007-11-10 10:23:05 · 5 answers · asked by Eugene 3

1970-1978 DATSUN which series is best for gasoline?and which is better overall and why?
240z?
260z?
280z?

2007-11-10 06:49:10 · 4 answers · asked by Anonymous

2007-11-10 05:14:15 · 3 answers · asked by Trena E 1

I cleaned the engine of my '99 Altima,causing the spark plug recesses to fill with water, this made the engine misfire untill I dryed the plugs, and it runs great now. However I have a service engine soon light and can't seem to reset it,does anyone know how I can reset it without having to pay a mechanic? I have turned the switch on and off 10 times, rapidly which worked on other cars but not on this one.
Any help would be appriciated. Thanks, YAHOO users.

2007-11-10 04:19:44 · 3 answers · asked by capnjfmcg 1

2007-11-10 03:06:32 · 3 answers · asked by njspanteach 4

2007-11-10 01:36:03 · 4 answers · asked by george b 1

i was told it is either a 1.8 or a 2.5 i dont see any of that on the engine it self

2007-11-10 01:06:41 · 0 answers · asked by Anonymous

the motor in the 4th gen is bad and the 3rd gen motor is for sale. thats why im swapping to 160 hp instead of 190.

2007-11-09 19:50:24 · 4 answers · asked by Dogmeat 2

Here's all that has been changed coil, plugs&wires, fuel filter&pressure regulator, crank angle sensor, distributor&rotor, Fuel pressure good, and the injectors are not leaking. It cranks over but will not fire over.

2007-11-09 14:22:20 · 8 answers · asked by Anonymous

what do i need to upgrade?

2007-11-09 13:36:42 · 3 answers · asked by Anonymous

Is it my thermostat or heater control valve? Or is it something else?

2007-11-09 13:02:14 · 7 answers · asked by mr.koffee 1

I could hear a lump, lump sound from the front of my car. I thought it was a bubble in the tire, but after replacing them and finding there was no probs with the tires, I found out it is the strut that need replacing. The car has 110k miles.

2007-11-09 12:32:17 · 4 answers · asked by ? 1

I want to know if anyone knows anything about the 300zx and the engine problems. from what i heard the earlier models have engine problems and the 1996 model they fixed them.

2007-11-09 11:32:44 · 4 answers · asked by kevin_thach23 3

it turns off randomly at a complete stop or about to stop, and it takes a good 5 minutes to start back up. I have put in it a new distributor, a different mass air flow sensor, i have done tune ups on it, all fuel parts have been checked, i only use high octane gas, and yet my mechanic and Nissan cant seem to find the problem

2007-11-09 10:05:42 · 1 answers · asked by Anonymous

2007-11-09 09:24:35 · 1 answers · asked by tregan01 1

I recently took my '95 Nissan Altima in because it started violently shaking. I was told the distributor was leaking oil and therefore throwing things off. I paid $45 to have the distributor cleaned (the only charged me for labor). However, they advised that I look into selling my car because a new distributor could run up to $500-600.

Any advice? Should I look into a new car? Any idea on how long this repair will last? Should I buy a new distributor?

2007-11-08 17:25:36 · 1 answers · asked by chicagominimal 2

2007-11-08 17:14:12 · 3 answers · asked by nando da cely 1

I have a red 2006 maxima and I want to put 20" rims on it. i have trying to find wheels from them but cant decide which ones to buy. any help would be appericated . . .

2007-11-08 15:18:04 · 3 answers · asked by seahhawk2003 1

fedest.com, questions and answers