Chevrolet

I have a 2000 chevy pick up and was planing on putting a new air intake unit on it. My father just put a K&N filter system on his 2007 suburban and absolutely loves it. I would like to out do him but I have heard that K&N is the about the best you can do?

2007-06-21 15:45:32 · 2 answers · asked by iliveforfridaynightlights 1

where would should i look to fix this problem it been driving me nuts any help will be great thank

2007-06-21 07:28:04 · 6 answers · asked by Anonymous

I'm looking at a corvette for 8k that had its 195hp 350 vette engine swaped for a rebuilt, more hp (at least 250) 327 engine. The corvette is in immaculate condition and I'm thinking about getting it however I'm afraid it'll depreciate value over time because of the engine. What do you guys think I should do?

2007-06-21 06:22:34 · 9 answers · asked by Louie K 2

I have a 9c1 95 chevy caprice, and was wondering if anybody had any advice on fixing the fuel gague? Am I going to have to replace the fuel sending unit inside the gas tank???

2007-06-21 05:55:40 · 8 answers · asked by native_playa694life 1

2007-06-20 22:37:09 · 1 answers · asked by beverly h 1

Its an 89 Chevy 1 ton, 454 TBI. I am getting fuel to the injectors, so I know the fuel pump is good. If you prime the truck, it starts. Replaced the fuel pump anyways, just to be on the safe side, and the electronic computer control. I also replaced the fuel relay. Any suggestions?? I don't want to put this beast in the shop, but I got to get her running. I need this truck. Any suggestions would be helpful.

2007-06-20 16:58:02 · 8 answers · asked by Kalighe 3

2007-06-20 12:42:19 · 5 answers · asked by Anonymous

car will idle for a few seconds but then cuts out, when it starts i put a lil pressure on gas peddle and it cuts out as soon as i put pressure on it. can n e one help me out with y it wont stay running? ive checked coil and its fine, timing is good cause it starts with one clik usually or wants to start, but dies when i put pressure on the gas paddle.... why is this?

2007-06-20 10:32:00 · 6 answers · asked by Ant F 2

i have a really noisy lifter, i am wondering how would i know what one is bad, i know it is on the drivers side so that knocks it down to 1 of the 6 on that side, if i had them all out, what would any signs be of it being the bad one?

1984 chevy s10 2.8L v6

2007-06-20 06:02:10 · 4 answers · asked by trivium332 2

Just wondering what made you buy the Chevy over the Toyota. Specifics please.

2007-06-20 04:03:24 · 3 answers · asked by InjunRAIV 6

does anyone know the horsepower and what the motor is called other than a350

2007-06-20 01:33:42 · 5 answers · asked by insearch of 1

please help have a brake job coming up on a 1999 chevy Monte Carlo and wanted to know the easiest way to remove them

2007-06-20 01:31:49 · 9 answers · asked by ajaaron5000 1

I have a 2000 Camaro Z28. It has had a Rattling noise coming from the rear (Posibly the right side) of the car since I had it (about 18k Miles). I was told it could need a rear-end fluid change a year ago.

I changed the Fluid last fall, and it still does it!

I was also told that it sounds like a U-joint by MANY people. So, I changed one of the U-joints that could have Possibly been bad. But, it wasn't. I changed a Good U-joint that didn't need chaged, and spent over $75 just to have it removed. The newer one isn't exactly as easy to move as the Old one...But anyway....

That STILL Didn't solve the Rattle I was hearing.

I belive that it IS comeing from either the Differential, or the rear-right wheel-Bearing. I can't exactly describe the noise, it is More of a Knocking sound. Almost a Rolling noise, consistent with the axle & wheel speed.

I would like for some REAL Experts to help me out with this one, since the Ya-hoo's in Indianapolis are of No help... :P

Any Advice??

2007-06-19 22:59:16 · 17 answers · asked by Diog 3

Cam=http://store.summitracing.com/partdetail.asp?part=SUM-K1105

RR= http://store.summitracing.com/partdetail.asp?part=SUM%2D141507&autoview=sku

I am trying to do a low buck build on a gen1 sbc 327 with Summit vortec heads that say they can handle a maximum of .520 lift..

Will these other parts work?

2007-06-19 18:49:47 · 3 answers · asked by ohmyhead69 1

Its a nice vehicle but I don't know anything about the safety, and don't know anything about the reliability.

Anybody have any insight? It is Dark Green, Automatic, and has a V6 4.3 Liter engine...

Thanks

2007-06-19 10:59:05 · 8 answers · asked by I'mdabess 2

2007-06-19 03:47:07 · 6 answers · asked by william 1

I am having problems with the digital speedometer, it goes on and off while driving, I've tried to find any fuses or wiring that was loose, does anybody have any ideas? Do i need to replace it or is it something simple? Anybody with any experience with the car?

2007-06-19 00:28:47 · 7 answers · asked by native_playa694life 1

Iv'e heard the new camaro will look nothing like the concept. IS this true ? What about a base price ?

2007-06-18 15:38:31 · 8 answers · asked by Anonymous

2007-06-18 15:21:59 · 8 answers · asked by Anonymous

2007-06-18 14:15:18 · 8 answers · asked by reflektionz98 1

mechanic says the anti theft cannot be disconnected

2007-06-18 14:14:36 · 5 answers · asked by Suzanne R 1

2007-06-18 13:34:23 · 6 answers · asked by Anonymous

2007-06-18 11:43:44 · 9 answers · asked by Anonymous

2007-06-18 11:40:52 · 19 answers · asked by donnarae4849 1

Can anyone tell me where the heater core is located in this car and if I can easily bypass the hoses and how I do that...

2007-06-18 08:15:25 · 6 answers · asked by babyjane8673 1

2007-06-18 07:57:58 · 4 answers · asked by Anonymous

2007-06-18 06:54:01 · 3 answers · asked by brown matter 1

This past week when I got into my car, I noticed the passenger side floor board in the front seat was really wet. I turned the car on and within minutes the temperature was the highest it would go on the gauge ( 260 ). I could then see smoke coming through the vents and smell antifreeze, but no leaking from any hoses or under the car?? There is no smoke coming from under the hood and the radiator is full!! Help please

2007-06-18 06:24:00 · 4 answers · asked by babyjane8673 1

2007-06-18 06:01:33 · 3 answers · asked by hellbentwwefan 2

I just bought a 2003 Venture 3.4liter. After the purchase was complete 2 days later I noticed that on top of the engine there was a "5.0" hand written in green and a few markings on the engine in yellow. I tried to locate the VIN # on the engine to see if matches the VIN# on the car but I can not locate it. And the dealership sold it to me obligated to tell me if this was a junk yard engine and what my rights are? I bought it on June 11 and today is June 18th. They might not have known if this was a Junkyard engine also but they have mechanics look over them before they put it in the lot. I need all the help I can get.
thanks
Oz

2007-06-18 05:21:16 · 4 answers · asked by Anonymous