Car Audio

We were driving down a bumpy road and we hit a bump and the radio and the clock went out and everyone keeps saying that it is a fuse but our mecahnce could find anything.

2007-05-30 09:37:35 · 1 answers · asked by pinkpuppy2012 1

can i cut and splice the REM of multiple amps into one line that goes to the front of the vehicle or should i run individual lines?

2007-05-30 08:36:51 · 2 answers · asked by Anonymous

I had a stereo put in at Best Buy in my '92 Integra. I'm thinking now about buying new rear speakers. When I look at the old one's, there is a capacitor soldered onto the terminals. Is that OE or did Best Buy put them there? (I think I remember him saying something about speaker protectors...is that what they are?) And do I need to put them on any new speakers that I might buy??

2007-05-30 08:12:54 · 3 answers · asked by coolbelair2000 1

2007-05-30 07:47:08 · 5 answers · asked by RUSSELL B 1

Is it worth purchasing a kenwood KAC-7203 amplifier for my car, or is there osmething wrong with them. Every amp i seem to buy people have something bad to say about it.

2007-05-30 06:47:47 · 4 answers · asked by brad a 2

2007-05-30 04:25:36 · 4 answers · asked by scott p 5

I want to install 2 car stereos in my car for lots of reasons so i can run my 8 track and my cd/mp3 player and not have to unplug and swap them around because it gets anoying after a while 8 track has got some good music nd i also like my rap

2007-05-30 00:56:25 · 10 answers · asked by Anonymous

I was wondering if I faded my sound to my front speakers and left all the bass in the back from my subs, would that sound better instead of balancing it out even with sound in the rear speaker sense the bass is taking over in the back?

2007-05-30 00:41:40 · 7 answers · asked by Cap504 6

2007-05-30 00:19:38 · 6 answers · asked by Anonymous

who controls the radio?, the driver or passenger??

2007-05-29 17:01:42 · 29 answers · asked by BO 1

I plan on putting two 300 watt RMS subs in a car. I am going to wire the subs in parallel to a one channel amp. Should I buy a 300 watt RMS one channel amp or a 600 watt RMS one channel amp for my subs?

2007-05-29 13:47:56 · 3 answers · asked by Got Subs? 1

the type x speakers have 75rms 150max.

2007-05-29 13:17:05 · 3 answers · asked by Brian W 1

Hi all,
How many RCA pre-amp outputs in an mp3/cd tuner are required to connect a system consisting of 2 pairs of speakers, an amplifier and a subwoofer enclosure? (If my amp has 4 channels)

As in, do i connect speakers and subs to the amp and then connect amp to the headunit or can i connect a pair of speakers and a sub to amplifier and then connect other pair + the amp itself to the headunit???

2007-05-29 12:29:17 · 2 answers · asked by Anonymous

I just bought a COBRA 29 WXNWST CB radio and installed it in my jeep using exactly 21 feet of coax cable. How long of a firestic should i buy? I thought about a 4 foot Turnable Tip
FireStik II. But i would prefer a 3 foot (so I can fit my jeep in the garage). My concern is that when i bought the coax cable they said i had to buy in increments of 3 feet... so should my antenna be 3 feet? please help thanks

2007-05-29 12:14:09 · 2 answers · asked by Anonymous

2007-05-29 04:48:39 · 2 answers · asked by renzoa80 1

Decided to go with Polk Audio SR6500 Components for the doors. According to Crutchfield they wont fit? The MOMO series 6.5's will fit. The difference is 5/8 in diameter. The MOMO's are 5", and the SR series are 5 5/8". I guess I could take the door panels off to measure, but I figured it couldnt hurt to ask here first. Thanks.

2007-05-29 04:47:04 · 4 answers · asked by 99TJ 1

OK, here is the deal, I have a kicker amp that runs a rms of 700 watts at 2 ohms, and is 2 and 4 ohm stable. I am looking at a subwoofer (kicker L7) that runs about 750 RMS at 4 ohms. So, If I hook that L7 sub up to the amp in a 4 ohm configuration, will I only get 350 watts of rms going to the sub since it is a 4 ohm sub and not a 2 ohm?

2007-05-28 23:17:42 · 5 answers · asked by Coma White 5

a stereo with an output to plug into my ipod, thanks

2007-05-28 19:34:51 · 12 answers · asked by Jonathan 3

I have a 2004 Honda Civic LX Coupe and right now I'm using a transmitter to play my music from my ipod, but no matter how low the frequency of the station I use is, I still get some static. I don't have a tape deck to buy one of those tape transmitters, and I've been thinking about getting an aux jack installed. Approximately how much would it cost?

2007-05-28 13:53:19 · 4 answers · asked by Anonymous

I want to install an add on alarm to my 05 Tacoma. I can't fine some wire. Anyone know of a web site that show wire diagram for alarm installation? Thanks in advance..

2007-05-28 13:41:18 · 2 answers · asked by Pit_Crew94 3

2007-05-28 12:51:06 · 2 answers · asked by winchester216 1

2007-05-28 12:22:51 · 2 answers · asked by Anonymous

I have a sony Cdx m-800, no wiring diagram thou. How do i set up the auto-dim? is there a wire that needs to be connected to the lighting?

2007-05-28 11:59:01 · 1 answers · asked by masterchief irl 2

it's a 1991 toyota tercel w/ a soundstorm smp3 100r cd/ mp3 player and a jvc tape deck. all wring was double checked and we installed ourselves (my dad's the a/v guy at his work and he's stumped). We know it's not cd/tape players themselves bc even though the warrenties are expired they've never been used ever.

2007-05-28 11:47:47 · 1 answers · asked by djmantiz 1

i have a 99 acura cl with a bose system and i would like to get more bass out of the stereo but want to keep all the speakers. any ideas

2007-05-28 10:59:49 · 7 answers · asked by footballpro56124 1

in the instructions it says i need an adapter what do i do?

2007-05-28 10:17:27 · 2 answers · asked by Anonymous

2007-05-28 07:52:52 · 3 answers · asked by James S55$$ where I give you ME. 4

please help me hook up my cd player

2007-05-28 06:05:51 · 3 answers · asked by ? 1

The guy who did it says he needs a wiring diagram can't figure out where my "orange illumination wire" goes on the wiring harness.

2007-05-28 04:53:39 · 6 answers · asked by barrgains 1

I have a 13w7 matched up withh a jl audio 1000/1 in the back of an SUV. The sub makes a popping noise when the volume is turned up and im thinking the reason is because the sub isnt getting any back pressure. The box is a poted design. Will stuffing it with Poly-Fill solve this problem? (money is an issue here too)

2007-05-28 04:52:00 · 5 answers · asked by Anonymous