Do It Yourself (DIY) - August 2006

Would putting plywood down first do the job? THe dip is probably about 2-3 inches

2006-08-22 10:04:07 · 5 answers · asked by Anonymous

2006-08-22 10:03:55 · 7 answers · asked by lizzard 1

I purchased a vertical Blind from an overseas supplier it was apparently supplied by Do It Best Home Centre - 9505 N W 108th Ave - Miami.....the installation manual was unfortunately not included - I am trying to obtain the manual - can you assist?

2006-08-22 09:40:26 · 2 answers · asked by latouchejean 1

2006-08-22 08:53:43 · 2 answers · asked by stoibull 1

We tried tripping the circuit breaker at the Electrical Box, it goes back on, still no lights. Any ideas???

2006-08-22 08:52:23 · 7 answers · asked by ssmithblueskies 2

2006-08-22 08:39:13 · 22 answers · asked by larhanaim 1

I'm renting a duplex, and need to install an invisible fence for my dog, who is a dachshund/Jack Russell cross. Has anyone had experience doing this, and if so, how hard and what kind of tools are need to put in the fence? Thanks in advance!

2006-08-22 08:32:01 · 7 answers · asked by aschryer0130 1

Can you replace laminate with a different color laminate, using the same counter/wood? I have off white laminate right now and I want to change it to black. Do I have to replace the whole countertops or can I peel off the existing one I have right now and replace it with black? Or can I put the black one right over it? Please help

2006-08-22 08:28:57 · 14 answers · asked by keziah 3

Please provide detail. Thanks!

2006-08-22 08:28:16 · 3 answers · asked by Katmando 3

2006-08-22 08:21:46 · 6 answers · asked by Babyboogy 1

We have recently replaced our bathroom sinks. We were wondering what type of glue is best to connect the sink to the counter.

2006-08-22 08:10:09 · 5 answers · asked by Radtech1996 4

how long till I can turn her back on... she was on her side for aout 3 miuntes, this is a very new appliance so hopefully there isnt too much gunk in the lines

2006-08-22 07:37:28 · 5 answers · asked by rots_loaner 1

2006-08-22 07:31:37 · 4 answers · asked by razzeriffic 1

2006-08-22 07:10:11 · 3 answers · asked by lucy 3

I have 2 toilet on my upper level of my home and both
will run intermittantly. If i flush the toilets it runs a normal cycle
fills and shut off. Then they will start running for no apperant
reason. I replace both wax seals and bent the float, adjusted
the float level screw. Could this be a vent problem i.e. wind blowing
accross my vent creating a low pressure and sucking water from
my bowl??

2006-08-22 06:50:57 · 10 answers · asked by james r 2

2006-08-22 06:06:21 · 3 answers · asked by cmb4444 2

2006-08-22 05:44:46 · 44 answers · asked by dash 1

2006-08-22 05:24:04 · 12 answers · asked by Anonymous

2006-08-22 05:07:58 · 6 answers · asked by Todd V 2

the pipe from my cooker hood is approx 6 inch diameter need a wall vent cover for outside house ,can only seem to find 4 inch cover ;please help...............

2006-08-22 05:00:07 · 6 answers · asked by bogit 2

I am looking to heat my home with a corn stove. Currently I use natural gas which is about $12.00 per unit (I can't remember the unit). I keep hearing about corn and it being more cost effective then natural gas.

How much does it cost per month in corn/electricity to run the stove? How warm will it be?

Any info would be appreciated! Thanks

2006-08-22 04:55:23 · 4 answers · asked by Arua 2

I'm looking for a wood that won't sag over time or be extremely heavy. I was told to stay away from partical board (will sag) and plywood (way to heavy). I want to stain the wood, not paint it white or anything like that so I need a wood that looks nice also. I was told to use a solid hardwood but I can't seem to find 'sheets' of wood wide enough to build an entertainment system. Any info (along with websites that sell the stuff) would be appreciated.

2006-08-22 04:28:37 · 3 answers · asked by J C 1

2006-08-22 03:49:34 · 2 answers · asked by Luke L 1

Is it worth the trouble of taking it back and complaining? Has anyone any experiences of making a fuss when DIY products don't do what it says on the tin?

2006-08-22 03:47:51 · 5 answers · asked by Anonymous

2006-08-22 03:00:52 · 9 answers · asked by polly a 1

2006-08-22 02:47:37 · 12 answers · asked by CB 1

2006-08-22 02:16:30 · 16 answers · asked by indian_don 2

My house has stucco walls. I'm trying to train a beautiful vine up the walls but every nail I hammer into the stucco either bends or a chunk of stucco breaks off. What am I doing wrong. Can someone give me step by step instructions, please.

2006-08-22 02:00:35 · 6 answers · asked by dealonbracelets 1

some of the stains have been there for a while some have not. I tried getting up when it happened with laundry detergent it got lighter but the stain was still there help me.

2006-08-22 01:57:06 · 10 answers · asked by violethue79 1

i just moved out on my own got 150.00 to spend what should i get

2006-08-22 00:54:33 · 2 answers · asked by congorela022000 1