Ford

Is there a recommended exhaust set up for a Ranger with the older OHV 4.0V6?

2007-03-10 15:12:55 · 4 answers · asked by atvman_400 5

2007-03-10 14:56:23 · 11 answers · asked by Adam B 1

2007-03-10 13:33:26 · 2 answers · asked by sharon h 1

my boyfriend is thinking about buying one...

2007-03-10 12:57:14 · 7 answers · asked by Anonymous

These are are painted white from the Blackjack factory and don't seem to have ever been run. They are for a small block ford 289/302/351W But.. I want to know what they fit. Do they fit mustang ii?

2007-03-10 12:20:37 · 3 answers · asked by John T 2

lost my keys 2days ago.for locksmith to come to my home will be $150 minimum.

2007-03-10 10:09:46 · 7 answers · asked by noah b 1

2007-03-10 09:17:14 · 3 answers · asked by rdra00 1

It slides like crazy in snow and rain. If I put on all season tires will it get along better? Should I put sand bags in the rear? How much does each all season tire cost for a For Explorer?

2007-03-10 08:15:10 · 3 answers · asked by I love screwdrivers! 5

2007-03-10 07:28:37 · 5 answers · asked by dorrnumberthree 1

I have changed the ignition switch & coil pack but still have no fire coming from coil pack?

2007-03-10 06:11:26 · 2 answers · asked by Joey S 1

The Passenger Door Is ALMOST OFF i need help

2007-03-10 04:59:32 · 3 answers · asked by Rodeny C 1

2007-03-10 03:10:44 · 8 answers · asked by marcelluswallace 2

2007-03-10 02:31:14 · 3 answers · asked by dsmith0628 1

2007-03-10 01:03:49 · 5 answers · asked by dorrnumberthree 1

I have a lot of play in the ignition and sometimes I cannot get the truck to start. Normally when you put the key in you see the check engine light and the ABS light come on, fuel pump activates and it starts right up. Then if I stop and come back to the truck and try to start it no light comes on and I do not hear the fuel pump activate. Is the an activating mechanism in the cylinder that tells the motor you want to start the truck? Could the ignition cylinder be bad?

2007-03-10 00:57:23 · 3 answers · asked by Anonymous

2007-03-10 00:23:32 · 3 answers · asked by paul o 1

Does anyone know what the warning chime is on the 2006 Ford Crown Victoria? The chime is the same one that sounds when you open the door or leave the keys in the ignition except that this one chimes 6 times then pauses and repeats the cycle 4 times. It does it first whenever the car is started then about every 30min after that. There are no warning lights. The seatbelts are fastened. We have two cars that just started doing this. Both of them started just after passing 30,000 mi.

2007-03-09 23:21:30 · 5 answers · asked by Mike 3

i've changed the 02sensor (mechanic expense) what else can iI do to fix this problem?

2007-03-09 14:31:17 · 7 answers · asked by I like old 104 1

it smokes black smoke while running

2007-03-09 14:16:12 · 9 answers · asked by rednexxx2002 1

i have a 1986 bronco i hooked a compression tester onto the first spark plug valve on that front of my straight six engine and its only showing 30 lbs of pressure on the tester....what possiblities am i looking at to fix here...could it be a blown valve or something else? when truck is running, and the spark plug is in the cylinder valve, when i take off the distributor wire from that cap theres no loss of power, but when i dissconnect the others, there is loss of power. please help with all your possiblities and how i can fix it. we checked all the other cylinders and they're fine the spark plugs are new...

2007-03-09 13:28:36 · 4 answers · asked by Whitney D 1

2007-03-09 12:15:14 · 11 answers · asked by Anonymous

I just got a 94 explorer not long ago and the rear interior door handle was broke so I replaced it... I didn't know that the pull handle part of the door panel (the part that has the window switch in it) and the door panel itself was sappost to come off together... I just unscrewed the two screws under the door handle and pulled off that pull part... Is there a way to fix it or do i have to get a hold new door panel now?

2007-03-09 11:48:48 · 2 answers · asked by thegeodeman2005 1

I know the right way it goes on but I need to know how to release tension so that I can get it all the way on. Any help or or sites would be really appreciated.

2007-03-09 11:27:46 · 2 answers · asked by SoySrtaBonita 3

Does anyone know???

2007-03-09 10:30:10 · 3 answers · asked by JustWondering 3

What is needed to swap from a 1.6se zetec engine to a 1.8se zetec, i will have the 1.8 block and the 1.8 ecu is there anything else i need to change this over in my Focus.

2007-03-09 07:39:05 · 7 answers · asked by Anonymous

2007-03-09 07:26:16 · 5 answers · asked by BogoInWaiting 1

Please answer the question. I'm NOT going to sell the car for a V8 so that's not an option. There's too many mods in there to make it worth it. Ok onto the question:

I am looking to supercharge a 1996 V6 Mustang with a stock engine. It has 120K miles on it and runs better than ANY other car I've driven. I take care of it. it's my baby. I would like to know what you guys think would be a safe amount of boost. I will be using the ATI Procharger Intercooled kit. I was thinking 7 or 9 pounds. Please just let me know how much boost you think I can safely run.

Also, after this motor runs down, I am planning to get a rebuilt Morana Racing V6 engine that will produce 500 HP boosted. YES 500 HP from a V6! I talked to Tom and he said that it wasn't out of range.

Sorry for sounding brash but I posted this question yesterday and really didn't get any answers to it, just some smartass comments. If you're not going to take it seriously then please refrain from posting. Thanks

2007-03-09 07:21:30 · 7 answers · asked by Anonymous

I just took my leased 2006 F-150 in to have the brake lights looked at. The dealership (I moved so I went to the closest one) told me that wires got fried and they had to order new wireing harnesses. That will be 5 total days without the truck. They said they could only provide a lease vehicle though Enterprise and would cover only $28.00 per day towards costs. Is something wrong here? I only have 13000 miles on the truck and I have to pay because Ford has a problem with their vehicle! No wonder Ford is losing marketshare! Has anyone else had this sort of problem getting a loner?

2007-03-09 07:15:39 · 4 answers · asked by Mike L 1

Do I actually pull the bulb from the housing or is there something else I need to do?I tried pulling it straight out and afraid the bulb will break in my hand.

2007-03-09 04:07:41 · 5 answers · asked by Kristopher H 2

Why? Have you owned one of these and have you driven both?

I have a Ford 1 ton 7.3L 4x4 Crew Cab long bed.

2007-03-09 04:07:36 · 8 answers · asked by Anonymous