Chevrolet

Ok.. Another question for u then..I read alot of inquiries on how to program the remote transmitters for other vehicles (Chevy). Is it pretty much the same thing for all, or is there specific instructions for this car? Bought the car used, transmitter worked for a couple days then no more. I replaced the battery and did the reset instructions on the inside. Car supposed to be on or off? And does it sound like I just need a whole new transmitter? Cost? Thanks!!!

2007-07-20 03:20:42 · 3 answers · asked by courtney c 1

My radio got locked and i don't have the code... how can i get it and what are the instructions???

2007-07-19 21:23:58 · 4 answers · asked by Alejandro D 3

I love my truck and it looks so awesome but i think the lambo doors will set it off what you think? keep in mind it is a super cab truck and full sized half ton.

2007-07-19 18:06:25 · 9 answers · asked by 2bit 7

2007-07-19 14:24:53 · 5 answers · asked by Lupe M 1

2007-07-19 14:08:55 · 4 answers · asked by Anonymous

I want some sort of 4in lift and hopefully 33 tires. However Ive only found that at about $1400. My boyfriend found a 2 1/2in suspension and 2in body lift and either 33's or 32's for $1200...but i was wondering if any of y'all new anyway to get at least a 4in lift (body and/or suspension) and either 31,32, or 33 tires.

My truck is a '98 Chevy 3/4 ton.
Please help!?!?!?

2007-07-19 09:08:40 · 9 answers · asked by Energetic Tomboy 2

2007-07-19 08:27:15 · 9 answers · asked by Anonymous

Does Chevrolet plan on fixing this problem any time soon? What causes this?

2007-07-19 03:17:44 · 7 answers · asked by Lee O 1

Shouldnt it come on when the car also gets hot??? Although, the car does not overheat.

2007-07-19 01:49:10 · 9 answers · asked by Anonymous

Every time it rains water seems to get into the actual frame of my car but can't find out where.

2007-07-19 01:12:59 · 7 answers · asked by Jack K 1

I plan on using mobil one synthetic oil. Its my first time changing my oil on my truck should I do anything different from when I change the oil on a standard gas motor?

2007-07-18 19:57:19 · 5 answers · asked by shortstoperic7_2000 2

2007-07-18 18:01:28 · 5 answers · asked by Alexandro05 1

my 96 Chevy blazer v6 4.3L vortec engine has high mileage, first off something happened to one of the pistons and caused a problem with the wrist pin, which causes the blazer to make a knocking sound, I am sick of problems, i want a new v6 4.3L vortec engine, don't need accessories like altenator and battery and compressor, ect, i need a long block, need it under 2 grand. help plz!

2007-07-18 17:05:27 · 7 answers · asked by cashfan28 2

when I go to start my my 2002chevy truck the starter skips and makes a spinning noise. most of the time starts after second attempt sometimes more. do i need to change the whole starter or the part attahed to it?dont no if its called silinoid.

2007-07-18 15:53:50 · 9 answers · asked by charlie 1

i have a 1980 z28 with a 350. i will be crusing with it but will the 600 cfm get funky if i need it to? it's manual.

2007-07-18 14:58:12 · 6 answers · asked by saxaphonist 4

I thought the original rear end was in my 70 Monte Carlo, but the code stamped on the axle shaft doesn't match anything I can find. It is 077 WC. I need to get axle seals, and some other stuff, but can't figure this out. Help!

2007-07-18 13:12:13 · 2 answers · asked by MAT 1

2003 chevy S10 2.2 liter

2007-07-18 13:02:32 · 9 answers · asked by Alex V 1

hey people i always hear that people want a 383 stroker from a 350 small block,whats the big deal?

2007-07-18 12:09:01 · 6 answers · asked by saxaphonist 4

i think it is front wheel drive, but funny there is no brake pads on the back....or so i know of

2007-07-18 03:30:07 · 5 answers · asked by Anonymous

I have a 97 1 ton with 6.5 diesel that will not run right. It will start and run but then it will die. After it dies it may not start back up for a while. I think there is something wrong with the kill switch. Does anyone else have any other ideas?

2007-07-17 15:03:38 · 13 answers · asked by gregoryb96 2

I am just wanting to tighten them enough to level the front end of my truck with the back.

2007-07-17 14:13:17 · 4 answers · asked by Jeremy K 1

i have changed the coil and checked all the wires cant find anything wrong

2007-07-17 06:10:50 · 3 answers · asked by tweakinfreak13 2

2007-07-16 19:03:42 · 3 answers · asked by Scott 1

In a street race

2007-07-16 15:59:01 · 9 answers · asked by Speedy 1

2007-07-16 14:51:37 · 11 answers · asked by crazy mike 1

GM has gotten a real pos. from korea, the aveo, and has put a Chevy nameplate on it. GM again is trying to screw the public. The Aveo is a real POS. "Unsafe at Any Speed" will be reprinted with a new chapter featuring the Aveo. No wonder GM's sales are in the toilet. Certified morons manage the company. Your comments please.

2007-07-16 14:14:11 · 5 answers · asked by Anonymous

Chevrolet 2006 LS Model

2007-07-16 14:00:38 · 2 answers · asked by Ray F 1

2007-07-16 11:36:20 · 14 answers · asked by Clayton G 1

OK. I was in a parking lot, I put in drive, and by the time it went into second geer The moter turned itself off. It made a clunk that made me thing the drive shaft dropped. I looked under the truck and nothing out of the ordinary. I also looke under the hood and everything looks fine. Just because I checked the oil and its fine (no water in it.) I also checked the the radiator and its fine. When I try to turn it over it acts like the starter has trouble turning the moter. Ive ckecked the starter and it fine too. I had the little 4,6 ltr rebuilt a few years ago, but the shop I went through is no longer around. Any ideas?

2007-07-16 06:42:15 · 5 answers · asked by Gunny K1lljoy 1

It is my understanding that the 2008 will have the 3.6 and not the 3.5. The Yahoo Auto profile for the 2008 lists the 3.5. What's up?

2007-07-16 02:07:09 · 4 answers · asked by nrborod 1