Ok.. Another question for u then..I read alot of inquiries on how to program the remote transmitters for other vehicles (Chevy). Is it pretty much the same thing for all, or is there specific instructions for this car? Bought the car used, transmitter worked for a couple days then no more. I replaced the battery and did the reset instructions on the inside. Car supposed to be on or off? And does it sound like I just need a whole new transmitter? Cost? Thanks!!!
2007-07-20 03:20:42 · 3 answers · asked by courtney c 1 in Cars & Transportation ➔ Car Makes ➔ Chevrolet
1. Open the rear compartment lid (trunk).
2. Remove Right side rear compartment trim for access.
3. Using a jumper wire with alligator clips, ground the transmitter program wire terminal. The door locks will lock and unlock, indicating that the receiver is in the program mode.
4. With the system still grounded, program all of the transmitters.
5. Press and hold the "LOCK" and "UNLOCK" buttons simultaneously for 10 seconds .
6. The door locks will lock and unlock, indicating that the transmitter has been programmed
7. Repeat step 4 for each transmitter to be programmed.
8. Remove jumper wire from the transmitter program wire terminal.
9. Verify operation of the transmitter(s).
2007-07-23 03:58:45 · answer #1 · answered by Curtis 6 · 0⤊ 0⤋
Use a jumper wire with alligator clips in order to ground the RKE programming connector. This is located in the trunk on the right side behind the trim. The door locks will lock and unlock. This action indicates that the RCDLR has entered the keyless entry transmitter programming mode.
While the programming connector is still grounded, program each of the keyless entry transmitters, one at a time. Press and hold the LOCK and UNLOCK buttons simultaneously on the first keyless entry transmitter. Hold the buttons for 10 seconds. The door locks will lock and unlock. This action indicates that the keyless entry transmitter has been programmed.
Repeat Step 4 for the remaining keyless entry transmitters. You may program as many as 4 keyless entry transmitters.
Remove the jumper wire from the RKE programming connector terminal.
Verify that the keyless entry transmitters operate correctly.
if this don't work you may need a new transmitter. costs about $55.00
2007-07-20 12:27:24 · answer #2 · answered by roseland2911 2 · 0⤊ 0⤋
If you stop by your local chevy dealer.The service dept will check your transmitters and make sure they are working correctley.And program them to your car.Hope this helps.
2007-07-23 21:22:58 · answer #3 · answered by HyperGforce 7 · 0⤊ 0⤋