Cars & Transportation - 24 September 2006

the waste gate dose not seem to be stuck is the any way to check the vac pipes as you can not see them

2006-09-24 00:35:56 · 4 answers · asked by Anonymous in Maintenance & Repairs

We want to put side pipe exhust pipes on the truck. Every one has them coming out of the cab we want then to come off the side like a motorcycle would. The only thing is we need step bars to get in the truck,, we could use the pipe but it would be hot and melt your shoes... Any one have any ideas where we might find some one that make this type of exhust?? or any ideas on how to fit the step rails on around the exhust?????

2006-09-24 00:34:14 · 2 answers · asked by emt9898 1 in Dodge

especially on the inside of the tire, or is that probably just due to it needing an alignment?

2006-09-24 00:33:16 · 7 answers · asked by Anonymous in Maintenance & Repairs

2006-09-24 00:27:50 · 7 answers · asked by Kasper 1 in Other - Cars & Transportation

My son has put a 350 in his blazer and did not move the motor mounts. He has cut a drive shaft down but it was still a quarter inch too long.
Is there any that will (from a junkyard) or any way to cheat the quarter inch. he says it has to be exactly 4ft ? Cheap is the way.

2006-09-24 00:24:56 · 4 answers · asked by justpatagn 3 in Chevrolet

I think the old cast head 2.8 liters are crap but the 350's are the best they have made.

2006-09-24 00:05:47 · 19 answers · asked by Anonymous in Chevrolet

3 month old 3,000 km run, Nissan X-TRAIL, gasoline engine.
No such a problem when engine is cold.

2006-09-24 00:05:46 · 5 answers · asked by engineer 1 in Maintenance & Repairs

I was told that it was like a transaxle sensor but I wanted to get some more feedback. Thank you

2006-09-24 00:01:57 · 1 answers · asked by chad p 1 in Maintenance & Repairs