English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Motorcycles - October 2006

[Selected]: All categories Cars & Transportation Motorcycles

hi all , i have a yamaha xj 600 n and after a ride of 25 miles or so when i switch off the engine it gushes oil out of a breather pipe between the engine and the rear tyre. it only leaks for about 3 mins then stops, the bike was serviced 2000 miles ago and runs very well please help regards all Russ

2006-10-17 03:46:55 · 9 answers · asked by tractortribe@btinternet.com 2

Hubby has just bought a new bike after passing his test in August. He is an experienced rider having had many years experience on a Cagiva Mito 125. However i have never been on a bike before and to be honest im just a little scared! What are is the best first -time pillion advice you can give?
Many thanks

2006-10-17 03:04:29 · 27 answers · asked by Keeliewheeliebin 2

2006-10-17 00:58:00 · 2 answers · asked by Anonymous

alpinestars sps gloves with carbonfiber knuckle protectors

2006-10-16 16:28:34 · 9 answers · asked by xbstreetfighter 1

dude i donk know what is going on but the freaking thing just wont come off.

2006-10-16 14:22:26 · 3 answers · asked by scattertheashes3 2

IM DESIGNING A RACING JACKET AND I NEED A FEW PATCHES SEWN ON PROFESSIONALLY.

2006-10-16 13:01:54 · 9 answers · asked by Johnny Low-Gun 2

Can someone help me, am getting a Super pocket bike in two months and i dont know which one to get i really like the x15 super pocket bike tell me pocket bike i should get. look at the numbers or which is the best In the market under $700
1.)http://www.tm-scooterhaven.com/fs_sb539.htm
2.)http://www.worldebuy.com/pbw-10S4.htm
3.)http://www.worldebuy.com/pbw-10x18.htm
4.)http://www.worldebuy.com/pbw-1059.htm
5.)http://www.worldebuy.com/pbw-10x12.htm

2006-10-16 12:48:04 · 1 answers · asked by GetYaPopcorn 3

2006-10-16 12:23:38 · 2 answers · asked by DIABLO BLANCO 1

I'm rebuilding a Ninja X1 pocket bike (the one from PepBoys) and I ditched the old motor and I need help figuring out how and where to buy one new...can you help me please?

2006-10-16 10:13:57 · 3 answers · asked by Anonymous

If so, how easy is it to install new bulbs?

2006-10-16 09:35:34 · 3 answers · asked by OH yea! 1

I am thinking about getting a dirtbike. I am not stupid and i know a decent amount about them but I would like some of your oppinions. The bikes i am considering are as listed: Yamaha YZ85, Suzuki RM85, Honda CR85 and a Kawasaki KX85. Can anybody tell me what the top speeds are on these bikes and give me your oppinion of the best one to buy. Thanks

2006-10-16 08:30:12 · 11 answers · asked by Steven G 2

Or an Aprilia? I just love those machines! Im upset becuase I'll never be able to ride in one. I know theres one that I can handle..which one?????
Im 5'4 and 120 pounds....
Or can I just ride in the back of one? Is it wrong that they are a turn on? HUGE!

2006-10-16 07:29:55 · 6 answers · asked by emjay 4

been problematic since he had it, he paid cash and took the bike, When I had it it ran fine so im a bit concerned - do yuo think he is trying to make an excuse as hes had a change of heart and is her entitled to his money back, I sold it as seen and have sent the reg doc to the dvla . As I say the bike was fine when i had it/

2006-10-16 07:13:06 · 22 answers · asked by latenight 1

i have removed the screws and footpegs and the case is able to move out alittle but feel as if something is holding it back because it springs back in when released.

2006-10-16 05:38:16 · 1 answers · asked by rob 1

yamaha warrior atv engine dies when you put it in rev . why?

2006-10-16 03:39:54 · 2 answers · asked by sawedoffsteve 1

Am looking for the original type that bolts onto the back of the air cleaner backing plate

2006-10-16 03:31:41 · 5 answers · asked by mauser90807 3

I was riding through the field and then tried shifting in reverse. When I pushed down on the shifter lever it wnt to neutral and then wouldnt go to reverse. When I tried it again the lever went all the way down and never came back up on its own and is just limp, moving up and down freely. Shaft threads are not stripped on the outside where lever meets the shaft. seems to be something inside crankcase...What is wrong?? What do I do??

2006-10-16 03:27:16 · 2 answers · asked by Anonymous

I am wanting to sell a honda automatic but i can not find out what is worth. Does any one no where i can find this out?

2006-10-16 03:19:54 · 3 answers · asked by Anonymous

Also any suggestions on whch web-site to source a second hand one would be appreciated.

2006-10-16 02:16:12 · 9 answers · asked by patrick a 1

I have a Honda XR80R and thinking of selling it. i dont know what a good price is for it. It is a 2000 model and is red in great condition.

2006-10-16 00:24:04 · 2 answers · asked by Anonymous

2006-10-15 23:58:04 · 4 answers · asked by crazy 1

yamaha RD350

2006-10-15 20:20:32 · 3 answers · asked by ubaid_kid 1

does anyone know where i can find a front farron for a 2006 ninja ex250r my gf had had a wreck and i caint find a replacement one anywhere on the internet

2006-10-15 16:25:26 · 2 answers · asked by studds12000 1

front wheel of motorcycle

2006-10-15 15:35:30 · 17 answers · asked by Anonymous

Can some one explain positive grounding? What is the advantage, if any over what I would call standard negative grounding where the battery cable running off the negative terminal is grounded to the engine block or motorcycle frame. I'm specifically interested to know why vintage British bikes were positive ground.

2006-10-15 14:37:47 · 3 answers · asked by Anonymous

A Friend is going to sell me a dirtbike for 200 dollars... but im wondering if 100cc is too small???

2006-10-15 12:09:07 · 9 answers · asked by Anonymous

fedest.com, questions and answers