If so, how easy is it to install new bulbs?
2006-10-16 09:35:34 · 3 answers · asked by OH yea! 1 in Cars & Transportation ➔ Motorcycles
Your bike has H7 bulbs. What's wrong, not bright enough?
To remove the bulbs -
-Reach around to the back of the headlight and unplug the wires to each bulb.
-Pull the rubber boots off.
-Turn the bulbs counter clockwise to remove them.
-If you buy the bulbs from a motorcycle dealer, usually the spacers are included (double check to make sure).
-Where ever you buy them, they'll need spacers for your bike.
http://www.electricalconnection.com/non-electrical/h4_shim.htm
2006-10-16 12:44:25 · answer #1 · answered by guardrailjim 7 · 0⤊ 0⤋
Make it fit!
Grind to fit , Paint to match!
It should, H4 is the common motorcycle headlight bulb, however if you have a plastic headlight cover instead of glass, the bulb may cause the cover to melt!
2006-10-16 12:22:48 · answer #2 · answered by Anonymous · 0⤊ 0⤋
This may be a dumb answer but since it was not addressed-did you replace the brake fluid you lost while installing the new rear set and subsequent bleeding of the brake lines? Is everything hooked up properly? Is there a kink on the line somewhere?
2016-03-28 12:02:47 · answer #3 · answered by Anonymous · 0⤊ 0⤋