Chevrolet

The other guages seem to be acting funny also. The oil pressure is higher than normal and I don't think the gas guage is working correctly either. The temp guage rises and gets close to the red zone but falls if I let off the fuel. Friends at work have suggested the thermostat, heater coil, fuses, and water pump. I checked all fluids this morning. I added some coolant (it was a little low) The fuse for the gauges is fine, but I replaced it anyway. The top hose on the radiator was getting warm, so I assume the thermostat is working. There were no leaks from the water pump, but I guess it could be going out. Can anyone help narrow down this problem before I have to put the truck in the shop? Thanks for any help you can give me.

2007-01-16 04:26:20 · 9 answers · asked by Anonymous

I need a 1964 Impala ragtop and it don't matter if it is a project car I just need one. I would like some websites or local dealer information.

2007-01-16 03:51:20 · 7 answers · asked by ilovenewyork 1

the engine is a 350

2007-01-16 03:28:56 · 7 answers · asked by ted l 1

I have a 1969 DZ 302 out of a 69 Z28 with a forged steel large journal crank, .60 over pistons, new rods and 2.02 heads. I have two holly 660's on a high rise manifold. What would be a good high rpm cam for this engine? I am also shaving and porting the heads and boaring the block over .60. This motor is for a swamp truck so I need a tough cam.

2007-01-16 01:39:09 · 12 answers · asked by Anonymous

2007-01-15 19:12:53 · 4 answers · asked by Ted D 2

had trans service and adjusted nearly two years ago; replace filter and check general condition about 60 days ago. think we added too much fluid. now, it appears to be slipping when changing from 1st to 2nd. my model is 2 wd with automatic. i smell fluid, should remove, empty, replace new gasket and refill properly?

2007-01-15 16:22:31 · 6 answers · asked by lee_c_92262 1

has anyone ever had to change the a/c compressor..what happened was it used? how much hp did you get from your duals and or a intake. my intake was bolted on i purchased it from ebay and i must admit i can feel the difference!

2007-01-15 14:22:35 · 3 answers · asked by saxaphonist 4

2006 chevy 2500 duramax 4x4. Got stuck today in 4x4 high. Noticed that front drivers tire was not spinning. Got out before going into 4x4 low. Not long after I got the truck I know that all four tires would spin in 4x4 low. Never checked in 4x4 high. Do I have a problem? Am not sure now if all four are spinning in 4x4 low. Will check tomorrow.

2007-01-15 14:04:58 · 10 answers · asked by James M 1

For a 1992 Camaro RS 3.1L

2007-01-15 12:53:07 · 4 answers · asked by Anonymous

2007-01-15 12:01:23 · 5 answers · asked by baglady52005 1

2007-01-15 10:38:11 · 18 answers · asked by steve c 1

now if i cut the pipe off after the y and run 2``pipe will that give me a different sound

2007-01-15 09:29:40 · 4 answers · asked by jeff w 1

but will i get the high pitched crack that i want by running smaller pipe right now i have duals with no muffler and 2.5 pipe will 2.25 pipe do the trick?

2007-01-15 08:50:44 · 4 answers · asked by jeff w 1

It is made THE CAVALIER DIVISION, then it has another division who made it called THE SEEBURG CORPORATIONRIGHT UNDER THE FIRST ONE. THE SERIAL NUMBER IS 490442
THE MODEL # IS CGD-C. IT IS 60 INCHES LONG 24 WIDE 36INCHES HIGH.

2007-01-15 08:20:53 · 3 answers · asked by Anonymous

2007-01-15 08:02:10 · 2 answers · asked by metalworker420 1

I know that these cars are built on the same platform, but I am trying to figure out if I buy a front end bushings kit for a 63 impala, will it fit my 63 catalina? Everything tells me yes, but havent gotten connformation on this. Any input would be helpful. Thanks!

2007-01-15 07:18:13 · 4 answers · asked by sematlock77 1

2007-01-15 07:14:49 · 10 answers · asked by mmmhmmm_2000 1

Ok, I just got rid of my 89 Mazda B-2200 and I now have a 98 Chevy Cavalier. I want to put some money in it to make sure its a nice car for awile, and also to make sure it lasts. How can I do this?

2007-01-15 07:09:34 · 5 answers · asked by awall71688 1

What are the signs of a bad head gasket on a 2000 chevy. malibu

2007-01-15 06:40:54 · 4 answers · asked by Ruby 1

where is the temp door located at in the vechile and what do you have to do to get to it? another question is is the door electric or is it vacum?

2007-01-15 03:13:39 · 5 answers · asked by Anonymous

We have a 1955 Chevy 2Dr for sale. It was my husbands first car. The VIN number on the dash is now missing and I would like to know where else,( besides the door panel) we could find the number on the frame on this vehicle. We do have the title, but can't seem to match the numbers on the title to the car.

2007-01-15 03:01:23 · 7 answers · asked by Robin H 1

heres the website www.usedcopcars.com/ads/2001igold/ad2001igold.htm

2007-01-15 02:08:01 · 10 answers · asked by eskimochild87 2

My 91 Silverado has a Carb looking two injector throttle body. Its got 200,000 miles on it. Does the injectors wear out? Would it be a good thing to replace the TB eith a carb?

2007-01-14 21:09:09 · 3 answers · asked by djm749 6

im interested in buying the comaro but there is no specifics about when it wil be launched

does anyone have a concrete date???

2007-01-14 20:07:43 · 7 answers · asked by razadil 1

2007-01-14 18:49:50 · 6 answers · asked by jade 1

For example, a 1973 Caprice & Impala looks like the exact same car. Whats the difference?

2007-01-14 17:37:48 · 7 answers · asked by Anonymous

I need to know the grade of oil that a 2006 chevy cobalt takes its the coupe and its just stock so its a non turbo

2007-01-14 12:53:55 · 15 answers · asked by The Dude 1

2007-01-14 12:07:07 · 5 answers · asked by sharpie 1

2007-01-14 11:09:00 · 5 answers · asked by billierocka 1

2007-01-14 11:08:11 · 10 answers · asked by Rebel3163 2