Ford

2006-07-08 04:33:30 · 12 answers · asked by Anonymous

Have you seen the new Ford car? It's called the Ford Fusion and I was wondering what everyone thought of it.

2006-07-07 20:41:53 · 10 answers · asked by toes_made_of_steel 1

od light blinking on and off. runs fine just doesnt shift when it is supose to. ive tried a soft pedal and a heavy pedal. no difference. it wont shift out of first unless i let off the gas.

2006-07-07 17:30:46 · 3 answers · asked by greg a 1

asembly

2006-07-07 17:21:36 · 2 answers · asked by Mario K 1

2006-07-07 17:16:36 · 9 answers · asked by pat p 2

2006-07-07 15:51:18 · 4 answers · asked by Kevin M 1

I do not see any clips on what i believe is the air filter housing. I removed two bolts but after further inspection, they did not appear to be holding it on. Is this just a major pain in the ***?

2006-07-07 15:22:31 · 7 answers · asked by sg 2

2006-07-07 11:05:54 · 7 answers · asked by Anonymous

It has been on for a month or so, and I have not had a problem. It is a 1996 Ford Bronco XLT with about 152000 miles on it.

2006-07-07 10:07:30 · 20 answers · asked by Anonymous

2006-07-07 09:24:38 · 6 answers · asked by Anonymous

2006-07-07 07:58:53 · 10 answers · asked by dopey 1

They're on my girlfriend's ka, but it looks like the tyres are too wide for the alloys. This makes them look like they're never properly inflated...

2006-07-07 07:21:42 · 7 answers · asked by pascal 2

When I turn on the air conditioning, I get a musty smell.

2006-07-07 06:56:41 · 11 answers · asked by ibbeach1945 1

it has a new fuel filter, fuel pump, high speed fuel pump my timing chain has not jumped any.

2006-07-07 06:55:42 · 6 answers · asked by dopey 1

2006-07-07 05:29:59 · 24 answers · asked by delawaregirl83 3

I have replaced the 390 with a 89 351w in my 1972 f-250
does anyone know where to find the harness(duraspark)for the 351w.w/out paying over 300 bucks for it. You wouldent think this part would be this hard to find all aftermarket vendors want like 350 to 500 for this harness. Good mail order sources needed
thanks :)

2006-07-07 05:10:29 · 3 answers · asked by The fuzzybunny 69in 1

My #2 cylinder (passenger side second from front) on my 4.6L W type engine -- 4X4 -- spark plug stripped the aluminum block.

Tried to get heli coil installed unsuccessfully -- since plugs are recessed so far down inside cylinder head.

Instead in order to get it back on the road, they "glued" the spark plug into the head -- and in the process got some glue on the tip of the plug (I'm guessing) based on the continually deteriorating performance. Body is in great condition.

I'm currently on the second engine -- first one blew at 99K miles and it was replaced with a 25K mile replacement (warranty work from Ford's extended warranty thank goodness). It now has about 175K miles on it -- so this engine has roughly 100K if I'm ciphering correctly.

Should I replace the cylinder head or entire engine -- in other words do I have to take the engine out to change the head?

Any advice would be appreciated -- and NOOOOOO getting rid of it cuz it's a ford is not what I had in mind :o)

2006-07-07 04:45:22 · 10 answers · asked by unusually large louis 1

let it be eye-catching!!!!

2006-07-06 22:35:15 · 12 answers · asked by KI 1

are all men the same with there cars. i have a boyfriend and all he talks about is his car car car car. are all men like that?

2006-07-06 21:39:58 · 37 answers · asked by mrs_pollard21 1

A f150 what is the highest mileage before its starts breaking down

2006-07-06 19:45:48 · 22 answers · asked by bira g 1

2006-07-06 17:32:03 · 7 answers · asked by archduke 2

someone somewhere makes a kit to put a smallblock chevy in it

2006-07-06 14:17:54 · 29 answers · asked by Anonymous

@ door, hatchback, white w/red racing stripes, has a 302-high performance engine,rebuilt tranny, new clutch, new 4 barrel carb, edelbrock

2006-07-06 07:54:37 · 14 answers · asked by ~me 1

The frame of my mustang if pretty rusted. In fact, the car is starting to sag in the middle. Is this repairable? If so, what should I expect to pay? Where should I go? Are there in expensive alternatives (ie. reinforcement instead of replacement). This car is a daily driver thats in good shape-other than the frame. Any recommendations?

2006-07-06 06:02:09 · 6 answers · asked by allstar2344 2

Does anyone know where the PCV Valve on my 95, 2.3L Ford Ranger is located??

2006-07-06 05:49:58 · 6 answers · asked by Dan Pepperman 1

2006-07-06 04:30:29 · 30 answers · asked by anel1203658 1

I am interested in purchasing a Ford Bronco. Is there room and is it's possible to install a 3rd row seat for extra passengers? If so, where do I go to have it properly installed?

2006-07-06 04:27:20 · 3 answers · asked by ? 3

2006-07-06 02:38:16 · 4 answers · asked by Trixie 1

2006-07-06 00:26:42 · 34 answers · asked by ibanezrocker35 2

2006-07-06 00:00:24 · 9 answers · asked by shyam p 1