I bought one of those 4x8 trailer kits from northerntool. The build and wiring went well. I tested the wiring of the trailer when it was just the frame and no wooden sides. Everything worked and was fine. A few days later after I added the wooden sides and floor, the lights on the trailer were not right. If you turn on one of the blinkers, all the lights on the trailer flash as if the hazard lights were on. Also, when you have the tow vehicle lights on, all the brake lights come on the trailer, but when you step on the brakes, all the trailer lights go off. It did rain yesterday before the floor was installed so the wires may have gotten a little wet. I am going to take apart the connections and clean the wires with sandpaper and tinners fluid. Does any have any other suggestions or heard of anything like this?
2006-09-16
17:30:58
·
5 answers
·
asked by
Amc
2
in
Do It Yourself (DIY)