If I had an acoustic guitar amplifier with 2 separate channels running on 50 watts per channel, could I plug my guitar through my Di box (or preamp) that has 2 outputs, and then run those 2 outputs through both channels on the amps, thereby using both channels at once and use 100 watts at once instead of just 50? Basically I want to use both speakers on the amp at once to make the sound louder instead of buying a bigger amp. Whereas if I plugged straight into the amp I would only use 1 channel. Is this Possible? Thanks
2007-10-30 10:32:55 · 4 answers · asked by james v 2 in Arts & Humanities ➔ Performing Arts
Most amps that have 2 inputs automatically use full power and both speakers when you use one of the inputs. The channel inputs are both going to the main power amp and then the speakers. Double check that only one speaker is working. Also, the two 1/4" jacks on a DI are usually IN and THROUGH - not 2 separate outputs. The amp you are describing would be very unusual.
2007-10-31 04:51:52 · answer #1 · answered by PJH 5 · 1⤊ 0⤋
What you propose is definitely possible. If the DI box or preamp has 2 outputs they can be run to 2 different amps, and you will get more power out of 2 amps than just 1.
If the DI box or preamp only has one output, you can buy a 1/4" "Y" cable to split the signal.
Make sure that both amps are plugged into the same circuit breaker circuit or the same phase, otherwise you might create a ground loop through the AC lines.
.
2007-10-30 10:38:35 · answer #2 · answered by tlbs101 7 · 0⤊ 0⤋
It is possible but it will either give you a more finely tuned tone or a nightmare trying to balance one side with the other. Power isn't usually a very big part of the equation with acoustics. If it's volume you're after, a straight ahead transistor amp (like a Peavy solid-state for instance) gives you the true, unblemished tone of the guitar and generally more volume with minimum distortion. Good luck with your experimentation. This is how people develop their signature sound, keep at it!
2007-11-02 16:55:54 · answer #3 · answered by Dave 5 · 0⤊ 0⤋
It would work, it would give a richer sound but it wouldn't sound much louder. Give it a try and see if the sound it gives you suits your music.
If you find you get a lot of mains hum, make up a lead for one of the inputs with the sheath not connected at the amp end.
2007-10-30 10:38:24 · answer #4 · answered by Anonymous · 0⤊ 0⤋