I have a Microtek Scanmaker 4800 that uses a 12V 1.25A power adaptor, which did not come with the scanner when I purchased it used. I've been using dismatching power adaptors but they always get both the scanner and the power adaptor hot if I leave it for too long. Apparently 12V 1.25A model is discontinued and everywhere it says out of stock. Is there any available adaptor with other specs that will work with the scanner? Thanks.
2007-07-01 12:56:13 · 2 answers · asked by xcdlee 2 in Computers & Internet ➔ Hardware ➔ Scanners
Get one that carries a little more current if 1.25 is getting hot, then get a 2.0amp The extra current being available will not hurt your scanner just be sure it is 12V. The reason for heat is nearly always related to running at near full current output.
The lamp in the scanner will always be warm if it is turned on. It should turn off if not in use.
2007-07-01 13:07:02 · answer #1 · answered by Tracy L 7 · 0⤊ 0⤋
Found one on an eBay auction for you!
http://cgi.ebay.ca/12V-Power-AC-Adapter-Microtek-SCANMAKER-4800-Scanner_W0QQitemZ280121970717QQihZ018QQcategoryZ51438QQcmdZViewItem
Good luck!
2007-07-01 20:00:32 · answer #2 · answered by matthew_hetland797 3 · 0⤊ 0⤋