just wondering
2007-04-20 12:56:15 · 5 answers · asked by macgyver 1 in Science & Mathematics ➔ Engineering
Shielding them or turning them at 90 degrees to each other will reduce the interferring effect.
2007-04-20 16:20:15 · answer #1 · answered by rscanner 6 · 2⤊ 0⤋
I agree with answer of Rich Z. I want to add something for parallel operation of transformers.
Parallelly operated transformers should have same secondary voltage and the same internal impedence (or nearly same) then only they will be loaded equally otherwise the one with lesser impedence will be loaded the most where as other will not be loaded enough.
2007-04-21 07:44:20 · answer #2 · answered by dipakrashmi 4 · 0⤊ 0⤋
If one brings power in and the other transfers it out...
Also, I have seen 2 transformers being used in tandem, where both the primaries and secondaries were connected in series.
The reason was, to allow these 50Hz transformers to be usable with a 25Hz power source (needed double the iron core).
2007-04-20 20:00:18 · answer #3 · answered by Anonymous · 1⤊ 1⤋
If you have their secondary windings in series you need to test before wiring them to make sure their outputs will be "in phase". Test -wire them in series and make sure their voltages are adding. If not reverse the wires on one of the output windings. That will ensure they are both at the same point in cycle and not one high while the other is low.
2007-04-20 23:33:38 · answer #4 · answered by Rich Z 7 · 2⤊ 0⤋
Well: it's called " Electrons where each 1 unit measures
100,OOO Volts which some times called Static Electricity can
be controlled by less source of Plus & Minus cells that has
the different Magnets whom react from each others !"
2007-04-20 20:16:02 · answer #5 · answered by toddk57@sbcglobal.net 6 · 0⤊ 6⤋