English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

the power tool says max input 2.8 kva. do i need a 3kva transformer to run this tool or is a 3 kva transformer to big. can i buy a smaller 1 kva unit that will run the tool?

2007-04-18 08:25:57 · 9 answers · asked by mike r 1 in Science & Mathematics Engineering

9 answers

The max size transformer it is able to handle is 2.8 kva, so buy 2.7 or smaller. Definitely dont go over, it will burn your tool out.

2007-04-18 08:30:28 · answer #1 · answered by Anonymous · 0 3

You should get a transformer rated for a load that is larger than the actual load, so the transformer won't burn up.

3 kVA is a good start. Something even larger would be a bit better, but those things are expensive when you start talking about 5 kVA and up. If you can afford a 5 kVA step-down transformer, I would get that.

.

2007-04-18 09:35:05 · answer #2 · answered by tlbs101 7 · 0 0

Use the 3 kva transformer. It prevents overcharges.

2007-04-18 12:13:42 · answer #3 · answered by Anonymous · 0 0

Yes, they will work, but not well. I have done it when no 230 volt supply was available on site. Best not let a safety officer catch you, He will be attracted by the noise and apparent poor performance of your tools. Strangely enough a SDS drill works quite well on concrete and brick, a jigsaw will work if not forced. and a circular saw turns into a deadly weapon, due to snatch. Unless you have a need for very powerfull tools, used continuously, invest in cordless tools, with a common battery size

2016-05-18 01:46:18 · answer #4 · answered by ? 3 · 0 0

240v is single-phase 2-pole.

110 is single-phase 1-pole.

'Max input' doesn't make any sense though - it should be 'maximum load'. If it is going to pull 2.8kva max (usually measured with a locked rotor) then you will need a 3kva to give you sufficient power.

You might want to post more details - or contact me with them, and I can try to help you (or contact the manufacturer and see if they recommend a specific transformer - or at least give you the specs to be looking for).

2007-04-18 08:41:42 · answer #5 · answered by Joe M 5 · 0 1

No u need to go bigger a 3kva should be ok normally they should take a 50% over load for a short time.

2007-04-18 08:31:28 · answer #6 · answered by JOHNNIE B 7 · 2 0

3 kva. 1 kva will burn up.
I am a journeyman electrician (ret).

2007-04-18 08:30:51 · answer #7 · answered by Anonymous · 1 0

Minimum to use is a 2.8kVA transformer - and it will run hot. This is going to be a MONSTER transformer though.

2007-04-18 09:07:01 · answer #8 · answered by turd 2 · 0 0

2.8 is MAX input anythang larger than that MAY burn up the tool why not be safe and buy the exact replacement transformer?

2007-04-18 08:36:33 · answer #9 · answered by Anonymous · 0 3

fedest.com, questions and answers