idk which one not smart
lol
2007-04-09 10:20:11 · 13 answers · asked by Anonymous in Sports ➔ Cycling
On my MTB, I like White Lightning or Finish Line Krytex. Both are dry lubes that dont' attract or hold as much grit.
On my road bike, I tend to use Tri-Flow most of the time, and Pedro's Road Rage when it's really wet. Tri-Flow is thinner and gets into the rollers easier in the winter when it's cold, and I use it on my MTB chain in the winter as well.
Anyone that thinks WD-40 is a lubricant also believes that Wal-Mart sells quality bicycles.
2007-04-10 02:27:07 · answer #1 · answered by Anonymous · 0⤊ 0⤋
WD40 is a resonable cleaning and protecting agent for car engines, but is completely useless as far as cycles are concerned. Same with 3 in 1.
If you ride in the wet, you want a wet, sticky compound that will not get washed off with the first muddy puddle. However, in dry conditions, this will work against you, as it will attract dust and turn it into grinding paste.
I use a sticky, wet wax in the winter and a dry wax in the summer (Finish Line). These are expensive compared to 3 in 1, but will save you a lot of money in the medium term. As well as lubricating, it will also stop your chain from binding and, because there is less stress, stretching. A stretched chain will wear your gears causing them to need replacing sooner than a well lubricated chain.
Luck
2007-04-10 01:01:00 · answer #2 · answered by Alice S 6 · 0⤊ 0⤋
Try not to use 3 in 1 or WD40 - the two most frequent types of oils found in the house. 3 in 1 is to viscous and will wind up attracting a lot of dirt. WD40 is primarily a rust remover and doesn't add much long term lubrication. Your best best is to go to bike store and buy a bicycle specific lubricant. I prefer a dry teflon lube because it is durable, but will not attract grit and sand which can ruin your drivetrain.
2007-04-09 10:52:49 · answer #3 · answered by Jay P 7 · 2⤊ 0⤋
I agree with one of the other postings, NEVER use WD40 on ANY part of any bike
for dry conditions, I like Pedro's Dry Spray Lube
for wet conditions, I like TriFlow Spray Lube with Teflon
both are usually available at bike shops
I have heard good things about White Lightning and Rock N Roll Lube, but I haven't used them yet
2007-04-09 13:35:20 · answer #4 · answered by Anonymous · 2⤊ 1⤋
Wd-40 is what its call implies..... a water displacer.... its extra of a water displacer than a lube.... a stable lube could be directly 30 weight engine oil, yet of path using oil calls for popular oiling and cleansing. A dry lube, a stable you are able to truly could desire to be graphite powder.
2016-12-08 22:33:27 · answer #5 · answered by ? 4 · 0⤊ 0⤋
i like to use Finish Line Krytex. its a wax-based lube, so it works best is dry conditions. after cleaning the chain, i apply a generous amount then wipe off the excess after letting it sit for a few minutes.
2007-04-09 15:30:56 · answer #6 · answered by Anonymous · 2⤊ 0⤋
Finishline range i find is very good. Don't use WD40/CRC as it picks up dirt and makes a 'paste' that wear's out chain rings, cassettes and chains.
2007-04-09 20:58:46 · answer #7 · answered by Anonymous · 1⤊ 0⤋
Use White Lightneing of Krytex. Both are very good and also used by armatures and professionals alike.
2007-04-10 14:08:35 · answer #8 · answered by vmaxflame 2 · 0⤊ 0⤋
go to a bike store and ask them I'm sure they tell u but I don't really think it really matters what kind of oil u use
2007-04-09 10:48:07 · answer #9 · answered by fist wrapped in blood 3 · 1⤊ 1⤋
I use 3 in 1 oil, and sometimes WD 40.
2007-04-09 10:28:47 · answer #10 · answered by Richard C 2 · 1⤊ 3⤋