English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

My 96 nissan quest has a factory alarm that goes off when i open the door w/ the key and continuosly stays on prevrnting me from starting the engine . I had to pull the fuse for the alarm to shut it down . Is there a way to disarm or disable it altogether? And if so can u provide me w/ the info. ?

2007-03-25 10:18:57 · 2 answers · asked by DONJUAN 1 in Cars & Transportation Car Makes Nissan

2 answers

i found this
to reset without keypad turn on ign. turn lghts on and off three times or more you should hear the locks click. when they stop clicking with light switch stop and start the car



Trying to find out how to enter a code on a Nissan Quest Van door keypad when you do not know the original code.



Behind the right-hand kick panel (on my '94 Quest, beside the drivers right foot when seated in driver's seat and where the foot mounted courtesy light is) is a computer madule. To get at it I beleive you only have to remove one or maybe two screws. Without unplugging the module slide it out towards the gas peddle. One the top you will see, either a printed or hand written (mine was printed) tag with five numbers on it. Copy that five digit number and save. Put the computer back and close up (rescrew) the panel. The owner's manual explains what to do next, but in simplified terms: Enter that code you just copied into the door pad and you have six seconds to enter a five digit code of your own. Just remember that you CANNOT use consecutive (ie: 12345 etc) or repeat numbers (ie: 22222). If you goof up, just reenter that code from the module and try again.

2007-03-27 14:59:23 · answer #1 · answered by jsn_ayers 4 · 0 0

Cut one of the wires leading to your alarm and splice in a switch.

2007-03-25 10:28:53 · answer #2 · answered by GregK 2 · 0 0

fedest.com, questions and answers