2007-03-17 16:27:21 · 6 answers · asked by james33581 1 in Cars & Transportation ➔ Car Makes ➔ GMC
Dealer with scan tool, Take all fobs with, They all need to be programmed when adding remotes.
2007-03-18 02:38:33 · answer #1 · answered by franklinbud8 3 · 0⤊ 0⤋
Cadillac Cts Key Fob
2016-11-16 17:08:32 · answer #2 · answered by goolsbee 4 · 0⤊ 0⤋
Remote Key FOB Information
Transmitter Programming
1. Close all the vehicle doors.
2. Insert the ignition key into the ignition lock cylinder.
3. Press and hold the door unlock switch.
4. While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
5. Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
6. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
7. Repeat the previous step to program up to 4 transmitters.
8. Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter programming mode.
9. Operate the transmitter functions in order to verify correct system operation.
2007-03-18 15:32:23 · answer #3 · answered by randyrich 5 · 3⤊ 0⤋
It has to be done by a dealer with a diagnostic scan tool
2007-03-18 01:17:06 · answer #4 · answered by Delphi 4 · 0⤊ 0⤋
Your own's manual should provide the directions. Or have the dealer do it.
2007-03-17 16:55:53 · answer #5 · answered by renpen 7 · 0⤊ 0⤋
take to dealer
2007-03-20 04:12:04 · answer #6 · answered by franksr57 2 · 0⤊ 0⤋