2007-03-09 05:33:17 · 6 answers · asked by Anonymous in Science & Mathematics ➔ Engineering
EDM-electro discharge Machine.
or drill and broach.
2007-03-09 05:42:56 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Suppose the side of a square is x unit,then drilled the hole of x dia after marking the square.Then file the remaining portion to make it a square.
OR use the punch and die operation.
You can use the unconventional machining like EDM or ECM, If it is a lot production.
2007-03-09 05:44:54 · answer #2 · answered by namrata00nimisha00 4 · 2⤊ 0⤋
With an Electric Welding Machine.
2007-03-09 05:42:55 · answer #3 · answered by Sam B 1 · 0⤊ 0⤋
I suppose it depends on how sharp you need to make the corners. If you need it sharp, then I'd probably use EDM. Otherwise, use a drill and a mill with progressively smaller bits to finish the corner with whatever radius you want.
2007-03-09 09:38:00 · answer #4 · answered by Elisa 4 · 0⤊ 0⤋
There are some lasers that are set up to pierce tubing. There are a few companies that specialize in this.
See below:
http://www.alspi.com/tubecut.htm
http://www.staublaser.com/services.asp?service=23
2007-03-09 11:23:34 · answer #5 · answered by rrohret2 2 · 0⤊ 0⤋
"Is it solid sufficient", possibly however the gadget became into no longer designed for this activity. i could use a power drill and drill bit, and de-burr the hollow. till you decide on a hollow greater than a drill bit, yet they're accessible as much as a million a million/4 inches, it somewhat is the biggest I even have in my gadget field.
2016-12-18 18:49:26 · answer #6 · answered by Anonymous · 0⤊ 0⤋