I would like to know whether I should cut the ends squarely or at an angle. I would also like to know which glue to use for sticking the ends.
2007-01-15 22:21:41 · 4 answers · asked by Bharat 4 in Science & Mathematics ➔ Engineering
O ring cut in angle because it will cover more area to stick.Use matlock industrial adhesive(made by pidilite- not sure).
2007-01-15 22:49:14 · answer #1 · answered by digish c 1 · 1⤊ 1⤋
The end joined O ring must not be stretched over the joint and the rest of the O ring must not be expanded to its elongation limit. Edges must be burr-free, radii and angles applied smoothly. Dust, dirt, metal chips and other particles must be removed. Tips of screws and installation housings for other sealing and guiding elements should be covered by an assembly sleeve.
2015-03-27 16:23:53 · answer #2 · answered by ? 3 · 9⤊ 0⤋
Contact cement would be another good adhesive for this purpose. It's very strong and flexible when it sets.
Do trim the ends at a mitred angle.
2007-01-15 23:29:39 · answer #3 · answered by poorcocoboiboi 6 · 2⤊ 1⤋
well you shold cut it at an angle where they fit together without much trouble and use rubber cement to hold it tpgether
2007-01-15 22:27:56 · answer #4 · answered by savannah 2 · 1⤊ 1⤋