English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

The right front speaker was working fine until someone stole my deck. I installed a alpine deck then it stoped working. The deck, amp, subs, and the rest of the speakers still work. I checked the wiring on the deck but it was fine the speaker and my tweeters were also fine. Can someone help me?

2006-12-30 22:16:35 · 8 answers · asked by Judy562 1 in Cars & Transportation Car Audio

8 answers

It is not a short in the wiring so you do not have to check the whole wire. A short (or ground) in the wire would cause all of your speakers to not play. so unless all your speakers are cutting out its not the problem. If wire is broken somehwere where it isnt touching the chasis to ground out could be problem. Also if it was wired backwards it would still play, the woofer on the speaker would just hit in reverse but would still produce sound. Try taking a 9 volt battery and connecting it directly to the speaker to see if you hear a small popping sound to make sure the speaker isnt blown. If you get a pop and your connection at both the speaker and radio are good then the radio might have a bad channel. to test that try hooking the channel up to one of the speakers you know works.

2006-12-31 01:48:45 · answer #1 · answered by sicmaggotmfkr 2 · 0 0

Humm, ya may need to check the speaker wire again "from start to finish"...or maybe the speaker wire comming directly out from the Alpine deck is out/lose/broken...the channel from the deck for that "right front" might not be good.

OR! the speaker it self needs attention.

Good luck
"/JOe

2006-12-31 06:26:01 · answer #2 · answered by "/ J()€ 5 · 0 0

easy test's

first take a multimeter and check the resitance in you speaker do this by taking the postive of the multimeter and putting it on the positive on the speaker and negative to negative you get the point. if there is no resistance (measured in ohms) you know then that the voice coil is blown and your speaker is in the junk.

2. if you do not have a multimeter hook the speaker up to you home stereo if the speaker works you know the problem is in your wiring.

i bet your connections are just bad. did you use crimp caps? trace the wires back and make sure all your connections are solid.

2007-01-01 03:05:08 · answer #3 · answered by Anonymous · 0 0

bad connection or broken wire. If the speaker is inside the front door, the wires between the door and the forward door post are often the sight of wire break downs because the door is always being opened or closed which means the wires have to move, causing metal fatigue and subsequent breaking of the wires.

2006-12-31 15:15:11 · answer #4 · answered by al b 5 · 0 0

The new board is not seated properly,
The board is defective,
the connections are not tight,
wiring is incorrect or backwards,
speaker (external) jacks or plugs shorted
or not seated correctly,
Or as others said possibly the speaker or it's wire
is damaged.

Hope this helps and Happy New Year to you :o)

2006-12-31 06:31:43 · answer #5 · answered by sr386 2 · 0 0

the head unit may have a burnt port,alpine has had a problem with that over the last few yrs

2006-12-31 12:52:44 · answer #6 · answered by JEFFERY 2 · 0 0

Try a different deck.

2006-12-31 07:25:09 · answer #7 · answered by doogie2man 2 · 0 0

might have a short in ur wiring

2006-12-31 06:23:49 · answer #8 · answered by phattygirl 3 · 0 0

fedest.com, questions and answers