how can you tell which speakers to buy for a jvc dvd
2006-12-30 07:28:25 · 5 answers · asked by Wonit5times 2 in Consumer Electronics ➔ Home Theater
I take it you mean a JVC DVD home theater system? If just the DVD player, then you will need a receiver to drive the speakers and something to plug in your DVD player.
Once that is taken care of, then I would suggest and good speaker system that has an impedance of 8 Ohms or 6 Ohms. A 4-Ohm speaker system may be too hard on many inexpensive receivers.
To get you pointed in the right direction to start, look for systems like the KEF KHT-1005 or the Hsu Research VT-12 systems. Proficient and Dayton Audio both offer a ton of performance for the money as well. If you want full-size front speakers, then the Athena system is a good choice.
_
_
_
_
_
2006-12-31 02:05:09 · answer #1 · answered by Anonymous · 1⤊ 0⤋
First you need to look at the back of the JVC DVD unit to see if you have the correct ouput jacks for surround sound (assuming you mean 5.1 surround sound). The DVD unit is only a player so the sound needs to be amplified somehow usually via a 5.1 receiver or powered speaker systems. Normally the unit will have one red and one white RCA (round jacks) in back of the unit. The source below can be viewed for more information on Home theatre hookups using a DVD plus it is a selection guide for other brands.
2006-12-30 09:01:52 · answer #2 · answered by ran959 2 · 0⤊ 0⤋
If it has a port for outgoing speakers you have to read the manual to find out which olms are used. Does the dvd have an output? If you buy a surround sound kit (any brand) it must have the exact same olms, or you will blow out your system.
2006-12-30 07:38:22 · answer #3 · answered by Jill S 5 · 0⤊ 0⤋
You can use any but you will need an amp and sub woofer, they come in one kit and any will do make sure your DVD has a decoder built in (most have these days) and a audio output.
2006-12-30 07:33:12 · answer #4 · answered by mfactor 2 · 0⤊ 0⤋
the only situation i will think of to envision is the mute button. See if it is on (the sub ought to mute to boot even if if it is well worth a glance). different than that, i think of you are going to be able to desire to have it repaired. The overload protection might close the receiver down yet does not do what your is doing. it may be unusual for the two factors of the amp to pass at as quickly as even if if it might desire to have an inner fuse so it might desire to be something so straight forward as that.
2016-12-31 08:01:46 · answer #5 · answered by valaria 4 · 0⤊ 0⤋