2007-12-19 14:00:49 · 5 answers · asked by tweety_mek 1 in Science & Mathematics ➔ Engineering
Based on the information given I can't answer the question but if you know the nominal diameter of the bolt, I can tell you the size of the wrench.
Take the nominal size of the bolt, multiple by 1.5 and add 1/16" to that answer. The result will be the size of the wrench to use.
Without the 1/16" you can have an interference fit.
2007-12-19 14:10:07 · answer #1 · answered by oil field trash 7 · 0⤊ 0⤋
Hi Yes you can measure the socket required bolt heads are measured across the flats that is a bolt head is hexagonal just measure from one flat side across the bolt to the other flat side the bolt holding the blade on my mower is about 32mm across the flats and allthough i have large collection of spanners this one is a bit big i allways use a monkey wrench or large adjustable spanner these are much cheaper than a socket ,just make sure it is nice and tight on the bolt then a gentle tap with a hammer and it should come undone ok take a picture on your phone before dismatling the blade just in case as sometimes its not obvious which way up things are , i take my blade off once a year to sharpen it , best of luck regards ward
2016-04-10 08:46:23 · answer #2 · answered by Anonymous · 0⤊ 0⤋
One that fits the bolts. Look on the plans or read the specs. There is probably a specific size and material bolt called for and a torque specification, too.
2007-12-19 14:11:46 · answer #3 · answered by Tom 6 · 0⤊ 0⤋
that 1.5 system can work on most bolts but structural bolts are usally a hard bolt aand nut and are larger then normal bolts
2007-12-20 12:56:13 · answer #4 · answered by Dan The Iron Man 1 · 0⤊ 0⤋
1.5 times the bolt diameter
2007-12-19 14:13:24 · answer #5 · answered by Helmut 7 · 0⤊ 0⤋