My well water pump runs constantly. The manual says it should kick off at 50 psi, it only gets to 48 (moves to 45 rather quickly, slow to 48). Water isn't an issue. Turned off all water to house, and still gets to 48, so I believe I can exclude leak somewhere in the house.
One place I called said it could be a bit of grit in the jet pump when I called. This seems like it could cost big bucks. Could I suggest for the service man to check anything else?
2007-12-18 23:28:11 · 4 answers · asked by jackiewilsonsings 2 in Home & Garden ➔ Maintenance & Repairs
You probably have a problem with your pressure tank. If it is the bladder type it could be broken. If it isn't it may need compressed air added.
A faulty pressure tank causes the pump to run constantly every time water is turned on in the house. You need to get the tank repaired if possible or replaced. Failure to do so promptly will soon burn out the pump from overwork.
If it runs even when water is not being used in the house then this is not the answer to your question. But if it goes on every time you flush a toilet or use just a little water it probably is what is wrong.
2007-12-19 00:08:06 · answer #1 · answered by Pixil 3 · 1⤊ 0⤋
I had the same problem with this in my home and I fixed it by simply adding air to my pressure tank. where your well line comes in there you should have a water softener and filters and a tank for holding pressure in the lines. shut off the water to the house and start filling the tank with air until you get to around 46 PSI once that's done turn the house water back on. It should take a lot longer for the pump to kick on now.
It's pretty easy and I would definitely try to do it yourself first before calling a repair man out. It'll save you a few bucks!
2007-12-20 05:22:23 · answer #2 · answered by skibm80 6 · 0⤊ 0⤋
Some things you could check for yourself. The volume control on the end, middle of the tank. This has a rubber in it and could have a Small hole.
Second, the diaphragm that controls the switch may have a ding in it, it would be hard to see or check, listen for any leaks. Make sire you use plumbers putty on all your fittings. If all else fails, call the pump guy.
2007-12-19 00:01:25 · answer #3 · answered by cowboydoc 7 · 0⤊ 1⤋
yes, call a service man to check and estimate repair cost.
2007-12-18 23:47:40 · answer #4 · answered by 1aton 2 · 0⤊ 1⤋