I laid floor tiles and used wickes adhesive. The adhesive does not grab the tiles properly. Can one recommend?

Answer 1

I want to agree with everyone, but since you didn't detail TYPE of tile; it might always remain a mystery to us?

For Ceramic, a THIN SET mortar is appropriate and standard. For Vinyl (even peel and stick) I prefer a water based contact adhesive; brushed or rolled on both the back of the tile, and the substrate.

Sadly; at this point; for YOU, options might mean removal and a re-do? I have a suggestion however; not having a clue where you are of what that BRAND substance is.

More than one suggestion actually. Even adhesives that come in cans/buckets; offer instructions regarding application. Did you follow them? (no offense)

I no longer use the "Slimey/Sticky", forgive that,,,even with an applicator with multiple tooth depths. That said, to attempt a FIX, you might try a contractor grade adhesive IE: Liquid Nails, and in its application it clearly states apply/ press/ pull/ allow to TACK/ re-press. The intent and effect is like contact cement.

Steven Wolf

Answer 2

Wickes Ceramic Tiles

Answer 3

what kind of tiles? I like Armstrong as my floor adhesive. Was the surface thoroughly cleaned and primed before applying adhesive? If using ceramic did you allow glue to cure before applying grout. If using self adhesive tile refer to above question If primed you can forego the glue . I have installed self adhesive that actually requires some adhesive spray in order to stick Grout does nothing to make tile stick

Answer 4

i presume you mean vinyl tiles, acrylic adhesive has to be left on the floor( after spreading) around 1/2 hour to 45 mins ( depending on room temp) before laying the tiles,,to be honest youre better off going to a trade flooring company for the correct adhesive, i find super stores own makes are rubbish,

if you let the adhesive dry you`ll find it goes tacky ( test it with your finger first) if its tacky proceed to lay your tiles

Answer 5

the surface that you glue the tiles to has to be very smooth and nonporous. if not then sand it smooth or smooth it over with a floor leveler. if it's just plywood, a primer sealer is a good idea. call lowes or home depot. they should be able to help you if you explain the conditions.

Answer 6

well, if your using ceramic tiles, you would have to put grout, in order to hold. you could find it at home depot.