Can I repair my lid switch on my washer? I was using a screwdriver tip to make the connection, but that's not

Question

working anymore. Do I really need to call a tech to fix it or is it fairly simple?

It's a
Kenmore 70 Series
Mod. 110. 20712990

How do I remove the "shell" in order to get to the lid switch? Two screws release the switch from "shell", but can't get to all of the wiring.

Answer 1

My husband removed the top and disconnected the lid switch. It is just for safety and we never have any children in the house.

Answer 2

Having owened a couple of Kenmore automatic washing machines the last one being a 1980-something model, I think I know and can picture what you're talking about. If I remember correctly, the top lid switch is a safety cutoff device that will stop the spinning of the basket during the rinse and spin dry cycles. It may not be the fault of the switch if this feature is causing the tub not to spin when it should, but it probably is. Also, if I remember correctly the whole top of the machine can be lifted up from the front (being careful not to wedge the operating panel on the back against anything and damage it) exposing the underside where the switch is mounted. It should have a couple of small screws attaching it to the underside of the top and a couple of wires that should be able to be unplugged fairly easily (don't break anything) for a new switch purchases from your nearest Sears parts department to be installed. BUT, WAIT !! Before your go to even that length, if your hubby has or can get hold of a volt/amp/cont meter, have him check when he locates the switch if there is continuity across the terminals of the switch in the position it is in when the top lid is closed (but with no electrical activity in the controls of the machine--control dial on 'Off'). If there is continuity, there is nothing wrong with the switch. There may be an open connection elsewhere in the circuit to the clutch that closes to spin the tub. You have to pull the machine away from the wall far enough the look in the bottom "machinery compartment" to find the connections to that clutch. Lotsa luck to you 'guys'

Answer 3

If you buy the new part it is very easy to install it. The secret to getting the shell apart is the control section in the back. Take the end caps off the control section to expose the rest of the hardware for removing the shell. You'll figure out the rest. It's not difficult. Check the pump to motor coupling as long as you're in there. I'd replace it if I were you.

Answer 4

I'd order the part and try to replace it myself first. you can always call someone in to do it if you can't figure it out

Answer 5

Unplug the power and "jump" (bypass) the lid switch

Answer 6

You could always take the part from an old model that someone has tossed out. Wont cost you a dime....just time.

Answer 7

this can be fixed . Give the brand and model # to your appliance dealer and they can order a new switch for you

Answer 8

Get a person who knows what they are doing,it cost money,
But you be alive not dead by electrocution

Answer 9

so you don't mess up call someone in

Answer 10

???????? You really need to mention the name brand and model for actual advice.