replacing clutch with new clutch kit got my clearance to remove transaxle, got transaxle detached, now i need to know how to get the metal ring around the boot of cv joint to tranny, not familiar with fwd cars, please tell me how to remove metal ring.
2007-10-20 10:29:12 · 4 answers · asked by Anonymous in Cars & Transportation ➔ Car Makes ➔ Dodge
You need to get a manual before going any farther. Go to your local parts store and buy one, or go to the library and copy the pages out of the manuals they have there.
The thin metal ring only holds the boot on the shaft, the boot only holds grease in place. Removing the boot will not remove the shaft from the transmission. You have to remove the shafts to remove the transmission.
And since you've already admitted you're not familiar with FWD vehicles, you need a book to get the correct procedures and torque specs for everything as you reassemble it. Not doing so can be VERY dangerous.
2007-10-20 16:01:42 · answer #1 · answered by Mark B 6 · 0⤊ 0⤋
I rather have/have had 4 Neons - 'ninety 5, '01,'02 and '05. My 'ninety 5 exchange into between the 1st added; an computerized. The others are handbook transmission geared up. All have been exciting and solid vehicles. regardless of the actuality that I experienced no issues properly worth pointing out, many different proprietors of first technology Neons ('ninety 5-'ninety 9) have pronounced head gasket mess united statesand varied oil leaks. the patron attempting out magazine, client comments, has constantly rated Neons, virtually as good for sturdy fill and little else. That pronounced, Neons are a cult automobile. they're decrease priced to purchase. there's a plethora of o.e.m/overall performance areas available. in case you bypass in this actual automobile, there are hundreds of different Neons calling your call. observe that the handbook vehicles are enormously quicker and much less costly than automatics. approximately 10% of Neon got here with stick shift.
2016-11-09 01:17:53 · answer #2 · answered by caton 4 · 0⤊ 0⤋
like mark says you need a manual on it,you cut the metal ring off the old cv joint boots,they give you new ones with the new boots,but honestly you should buy a replacement axle for it,their better and they come with a warranty,yours may seem ok for a while,but in my experience with them,they will give problems later on,its up to you though,but expense wise,it will save you money and time to replace the whole thing now while its out,and get a manual on it,there really helpful,good luck on it.
2007-10-22 16:36:11 · answer #3 · answered by dodge man 7 · 0⤊ 0⤋
You are suppoes to remove the axles first.
2007-10-21 14:19:08 · answer #4 · answered by Jackolantern 7 · 0⤊ 0⤋