I have a plastic water tank with an approximately 1 foot open hole at the top of the tank and a fitting at the bottom of the tank which is about 3 inches in diameter at the max. I need to heat the water to about 30-40 degree celsius. I was wondering how this could be done.
2007-10-18 10:56:05 · 5 answers · asked by Jeremy L 1 in Science & Mathematics ➔ Engineering
I'd go with the immersion heater idea. It should be rated for about 1000W.
.
2007-10-18 11:55:26 · answer #1 · answered by tlbs101 7 · 0⤊ 0⤋
i think of you're on the incorrect song once you're attempting to maintain money on heating the water. at the start, 40 gallons is a piddling volume of water for relatives use. Secondly, how a lot electrical energy will you be making use of at 250 watts cases 2, to warmth water? third; the bulbs will, i think, overheat in that restrained area and the climate will blow. yet i will see the kind you're questioning; that's the intial heating-up of the water from very chilly that consumes the main power, isn't it? it rather is consumer-friendly know-how. So why do no longer you proceed alongside with your concept of a water tank. Paint it matt-black and internet site it someplace to capture sunlight. The matt-black will take in the warmth and raise the temperature of the water, fairly if the tank may be surrounded by glass (Greenhouse consequence) to maintain cooling winds off the tank. The eternal conundrum with maximum of those power-saving schemes is the value of creating and setting up the equipment. by the time all of that's factored into the so-referred to as saving, there isn't any saving. consistent with danger the main inexpensive thank you to maintain warmth is to safeguard it by lagging the water tank to maintain the warmth in. because of the fact which you have have been given a furnish of LP gasoline, why do no longer you are attempting working your motor vehicle on LP gasoline? I do. 0.5 the value, so what you preserve on motor vehicle expenses, you are able to placed in direction of heating your water.
2017-01-03 21:23:29 · answer #2 · answered by Anonymous · 0⤊ 0⤋
Safest way IMHO is solar. Paint the tank black to attract IR radiation from the sun and let the tank receive the sun's rays.
You'll consume no costly energy. And it's simpler.
2007-10-18 14:57:25 · answer #3 · answered by Anonymous · 0⤊ 0⤋
you could use a water heater that's used to heat fish tanks get it from a pet store
2007-10-18 11:00:58 · answer #4 · answered by ? 1 · 0⤊ 0⤋
immersion heater thur the top
2007-10-18 10:58:37 · answer #5 · answered by Anonymous · 1⤊ 0⤋