what will happen if I connect 3 ohm speakers to a 4 ohm amp?

Question

I have a samsung q70 5 disk amp and have just bought samsung 3 ohm speakers......5 speakers and a samsung subwoofer.....will i damage the amp with this hookup...
[e-mail] thanks mike

Answer 1

you will get a refund of 1 ohm!

Answer 2

Wow - some strong questions. enable me clarify some concepts that would help. "audio gadget replace their impedance" An 8 ohm speaker is in basic terms 8 ohms at the same time as playing a million frequency of sound. the finished phraseology is that a speaker is 8 ohms "nominal". imagine of "nominal" as well-known. A "finished-variety" speaker has a tweeter, mid-variety and a woofer. as a rule: Woofer - is 3-6 ohms Mid-variety - is 7-10 ohms Tweeter - is 11-30 ohms So the impedance of a speaker relies upon on which driver is generating the sound at that second. The closer you get to 0 ohms - the closer you're to a short-circuit which could over-warmth your equipment and shrink the existence span. the following is the different idea: "Amp skill alterations at the same time as impedance of the audio gadget replace". there is no such element as a "8 ohm" amp or a "4 ohm" amp. you may pass to the Yamaha website and for an same AV Receiver see something like the following: 80 watts@ 8 ohms non-inductive load one hundred and twenty watts@6 ohms non-inductive load one hundred and fifty watts@4 ohms non-inductive load See the way it extremely works? be conscious: "non-inductive" skill they used a confusing and quick resistor to degree. This eliminates the challenge that audio gadget replace impedance at diverse frequencies. Your question states "If an amp says 4 ohms".... yet that makes no sense by technique of itself. you're lacking that someplace contained in the documentation - there's a skill score that the amp aspects to output at the same time as hooked as a lot as a 4 ohm load. that similar amp can artwork with 6 ohm audio gadget and eight ohm audio gadget. that is in basic terms about continually secure to apply 6 or 8 ohm nominal audio gadget on any good amp. wish this helps.

Answer 3

As long as you don't play your system at a high volume, it should work OK. But to be on the safe side, I would recommend buying a 1 or 2 ohm resistor for each of your speakers, and wiring it in series with the amp connection. It takes a bit of work to do this, but the safety factor is worth it. The reasoning here is that if you put too low a load on an amplifier output, it can burn itself out. You should be able to get these "load resistors" at Radio Shack, the Source by Circuit City, or any other good audio-electronics store with servicing facilities.

Answer 4

Hello AAMIKE. I don't think you will have a problem . A mismatch of one ohm is negligible. A mismatch of four ohms is a problem.Speakers have a "nominal" impedance rating which means "average"This is because the speaker's impedance will vary throughout the speaker's frequency range .This variation can be as wide as 2 to 40 ohms.The amount of variation ,in addition to how low or high the range, determines how difficult the speaker is to drive.The amplifier must be able to deal with these impedance variations,producing the amount of power necessary to drive the speaker at any frequency.If the amplifier is not capable of dealing with the impedance swings,audible distortion occurs. Most of todays Amplifiers can cope with the variations.Some amplifiers state their Stability in their Owner's Manual.
Hope this helps.

Answer 5

youll get 7 ohm speakers

Answer 6

your speakers should work just fine...