I just bought a used 2003 liberty and tried 4 wheel drive, got it into 4-lo and now I can't get it back to anything else!! HELP!
2007-10-06 13:22:34 · 5 answers · asked by oxhockey 1 in Cars & Transportation ➔ Car Makes ➔ Jeep
Well this can be tricky. I can be a solenoid/actuator stuck or it can be mechanical. Not including any other tcm problem.Have you tried to take the linkage/cable off the transfer case and manually see if the it comes out of 4low?
2007-10-06 13:41:27 · answer #1 · answered by alleeduster 1 · 0⤊ 1⤋
If you tried out the 4wd on dry pavement, the lack of wheel slippage is likely not allowing your 4wd system to unlock. Drive the vehicle on a grassy or gravelly area and put it into 2wd and then put vehicle in reverse and back up with a fairly high level of acceleration... of course make sure nothing is behind you. This should cause the 4wd to release.
2007-10-06 22:04:06 · answer #2 · answered by mikesimsr 2 · 0⤊ 0⤋
Do what Nigel M says,it has to be rolling 2-3 mph then put tranny in neutral and shift back into 2 wd.
Same goes when shifting into 4 Low,2-3 mph,tranny in neutral, shift to low range ,put tranny back in gear.
High range in and out at any speed,not under power though
2007-10-06 22:38:26 · answer #3 · answered by Lee K 4 · 0⤊ 0⤋
Place transmission in neutral while rolling 2-3mph, and move transfer case lever to desired position (2WD, or 4WD Hi Full Time) place transmission back into drive.
2007-10-08 22:39:23 · answer #4 · answered by Bill S 6 · 0⤊ 0⤋
Are you putting the transmission into neutral, with the vehicle rolling, before trying to shift the transfer case?
2007-10-06 22:13:26 · answer #5 · answered by Nigel M 6 · 0⤊ 0⤋