its all in one piece with i think the proper amount of grease within i reattached to the wheel and left other in apart its not spinning ???? hhhheeeeellllpppppp!!!!!!! very frusterating
2007-10-05 05:32:34 · 2 answers · asked by launchpad 2 in Cars & Transportation ➔ Motorcycles
the one end that goes into the tire is different looking then the other end ? the end that goes up into the speedo part looks kinda rounded at the tip of it?
2007-10-05 17:49:07 · update #1
Make sure the lower end is engaged in the speedometer drive mechanism. The cable end has a slot in it which has to engage in a mirror image tab inside the unit. Take the cable loose at the speedometer and twist it with your fingers while pushing down on it a bit and it should engage. When engaged, there'll be approximately 1/2 inch of cable sticking above the upper end of the cable (not the nut).
2007-10-05 08:21:14 · answer #1 · answered by bikinkawboy 7 · 0⤊ 0⤋
Are you sure its the cable? If you've had the wheel out it may be the speedo drive gearbox. It has a couple of tabs which must be aligned into slots on wheel. The inner cable should slide out from outer through the bottom end, it could be broken internally
2007-10-05 14:47:12 · answer #2 · answered by 1crazypj 5 · 1⤊ 0⤋