how can i program my 2005 gmc yukon keyless entry transmitter withou going to the dealer cause they charge 60$

Answer 1

cycle ignition 3 times fast with key on press and hold lock button for 10 seconds and locks will cycle you will hear each remote has to be programed

Answer 2

Transmitter Synchronization Resynchronization may well be mandatory because of the threat-loose practices technique utilized by employing means of the RKE gadget. The transmitter does no longer furnish the comparable sign 2 situations to the receiver. The receiver won't reply to a demonstration which has been till finally now sent. This prevents absolutely everyone from recording and taking part in back the sign from the transmitter. Resynchronization may well be mandatory if any of listed here are genuine: - you alter the transmitter battery. - You disconnect the vehicle battery. - You push the transmitter button 256 circumstances out of one in all those the receiver. as a thank you to resynchronize the transmitter with the receiver, carry out here steps: Stand close to to the vehicle. concurrently press and carry the LOCK and launch buttons on the transmitter for seven seconds. The door locks would desire to cycle to verify resynchronization.

Answer 3

Yukon 2005

Answer 4

Try this link! It works, too. You can program up to 4 remotes.

http://www.programyourremote.com/

. Close all vehicle doors.

2. Insert the key into the ignition.

3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold down until instructed
to release in step 9.

4. Perform steps 5 through 8 in fairly rapid succession.

5. Turn the ignition switch to the ON position (as far as you can go without starting the engine).

6. Turn the ignition switch to the OFF position.

7. Turn the ignition switch to the ON position.

8. Turn the ignition switch to the OFF position.

9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.

10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the door locks and unlocks.
This step may take up to 30 seconds.

11. Repeat step 10 NOW for each additional transmitter (including any existing transmitters).

12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode.

Answer 5

2005 Yukon

Answer 6

Maybe, but I'm not 100%

Answer 7

Good replies, just what I was looking for.

Answer 8

I should charge

http://www.spasticpuppy.net/keylessentry/index.html