What makes a Carver amp go from 8ohms to 6ohms? Is it the speakers or how the amp is hooked up?

Question

Bacisly how do you get more power out of a Carver 2 channel.
Does a 8ohm speaker and a 6ohm speaker sound different out of the same amp?

Answer 1

Hi.Lets say we have a speaker with a nominal rating of 8 ohms.The term "nominal" means average because a speakers impedance will vary throughout the speakers frequency range.A variation as wide as 3 to 40 ohms is possible.The amount of variation in addition to how low or high the range,determines how difficult the speaker is to drive.The Amplifier must be able to deal with these impedance variations ,producing the amount of power necessary to drive the speakers at any frequency.Your Carver Amplifier uses a Magnetic Field Amplifier technology and supplies power on demand from the speakers.So there is no need to be concerned about the 6 ohm rating.

Answer 2

You'd need to use a 6 ohm speaker instead of an 8 ohm speaker. The 6 ohm speaker will draw more power from the amp, and may be louder if it is the same efficiency as the 8 ohm speaker.

Now, if the amp supports 4 ohm operation and bridging, you could connect an 8 ohm speaker to the amp in bridged mono. This may put up to 4 times as much power to the speaker, if the amp has a good enough power supply section.

Answer 3

properly speaker impedance is very a nebulous element. there is "nominal impedance" and DC impedance. Impedance varies by ability of frequency. it is the place nominal impedance is obtainable in. At some frequencies it could fall lots decrease that the rated nominal impedance. So what's all this recommend to you? It ability that that 6 Ohm speaker could artwork merely large or it ought to reason one facet of your amplifier to run warmer and fail upfront if the receiver is unquestionably rated to potential audio device of a minimum of 8 Ohms. It won't sound precisely an analogous because of the fact the 8 Ohm speaker the two and that's no longer merely because of the fact of impedance. it quite is a various layout. possibly you do no longer care if it sounds slightly diverse. Who am I to decide? in particular, decrease impedance audio device play louder, no longer softer, than greater impedance audio device of comparable layout yet this additionally relies upon on the amplifier's layout. yet you need to be fiddling with hearth, possibly no longer an extremely heat hearth (4 Ohm audio device or the three Ohm audio device that contain those multi functional systems could be so lots extra risky) yet there's a danger that smoke could consequence from it and that smoke could upward push out of your amplifier. while you're conservative and don't crank the quantity up the smoke could perhaps stay interior all the wires interior the amp. yet once I have been you i could the two get the broken speaker repaired or get a sequence of effective, matching 8 Ohm audio device.

Answer 4

one makes amp work harder do you know about series parrel