2007-09-09 04:20:45 · 4 answers · asked by Anonymous in Cars & Transportation ➔ Car Makes ➔ Dodge
the blower motor resistor was on the outside of the van attaches to the firewall until 2000. 2001 and newer minivan resistors are on the heater box inside the van. open your glovebox, you will see a tab to press on top so you can completely remove the door from the dash. behind the opening you will see a rectangle peice screwed straight in to the heater box with 2 8mm screws. it has one connector with 2 wires (1 black and one green, this goes to the blower motor), and another connector with approximately 5 or 6 wires that comes from the control head on the dash. remove both connectors and the 2 screws and it is out. the whole job should take less than 5 minutes. the hardest part may be getting the glovebox off if you have never done it.
2007-09-09 11:24:02 · answer #1 · answered by sprinkles 6 · 0⤊ 0⤋
Resistor's are found on the heating ductwork either under the hood by the firewall or under the dash---usually, right hand side behind the glove box by the blower area---buy a new one so you'll know what to look for.
Eautorepair.net has online access to service manuals for a small fee---info will be in there too.
Sorry, Dodgeman, beat ya to it.
2007-09-09 11:50:04 · answer #2 · answered by paul h 7 · 0⤊ 0⤋
when you raise the hood on it look to the left of it and you,ll see the heater box,the resistor mounts on that part of it about half way up,it has a small wiring harness on it,and two screws that hold it on,most parts stores should have this part in stock,if not they can order it and have it the next day,it cost around 20-30 bucks most of the time,and is real easy to replace,good luck on it.
2007-09-09 17:10:51 · answer #3 · answered by dodge man 7 · 0⤊ 1⤋
I refer this question to Dodgeman.
2007-09-09 11:26:35 · answer #4 · answered by reddcobalt07 3 · 0⤊ 0⤋