How to program keyless remote to a 2003 350z?

Answer 1

well the problem is probably the computer
you should disconnec the car from the battery
for a few minutes
then reconnect it

Answer 2

Very Simple

1. Get in the vehicle and lock all the doors
2. Stick the Key in and out of the ignition 6 times, when you remove the key on the 6th time, the blinkers should blink.
3. Once the blinkers blink twice, place the key back in the ignition and turn it to the ON position (Not start the vehicle, but just to the ON position)
4. Press Unlock on the Remote
5. You are DONE! If you are program more than one remote, after you hit UNLOCK on the 1st remote, the Blinkers should blink, after they are done, hit Unlock on the door and Lock it again on the door and just hit Unlock on the second remote.

To test and see if it works, you have to exit the vehicle first.

Hope that was simple enough for you, good luck!

Answer 3

1. Close and lock all doors with the driver’s side power lock/unlock switch.

2. Insert key into ignition and remove it from the ignition key cylinder at least six times (sometimes takes more than six times) within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. ( Withdraw key completely from ignition cylinder each time ) . If this procedure is performed too fast, system will not enter programming mode.

3. Insert key into the ignition cylinder and turn to the ACC position.

4. Within 5 seconds, push ANY button on the keyless remote. Your Hazard Lamps should flash. ( Do not press the button more than one time in the above step). If the button is pressed more than one time, the programming procedure will not be successful.

5. If there are any remaining remotes (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each keyless remote (including any existing keyless remotes).

6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.

Answer 4

I have the procedure on my computer. E-Mail me [e-mail] The next answer is correct do that procedure. I got your Yahoo answers E-mail and cannot e-mail you back directly with an attachment... J.P.