Do I have to sand the floors after or just sweep and POLISH? Please help!
2007-08-16 06:04:13 · 8 answers · asked by Anonymous in Home & Garden ➔ Decorating & Remodeling
It really depends on what those floors look like. In some cases the person who added the carpet did so because the floor underneath was just plywood or it was hardwood except for a place where termites ate it and they put cheap wood over that hole.
If you are lucky and there are no defects and if you like the appearance then no sanding and refinishing would be needed - but don't count on that till you pull up the carpets and check it out.
2007-08-16 06:13:43 · answer #1 · answered by Rich Z 7 · 0⤊ 0⤋
The other problem you will have that you need to consider, is you will be able to see where the tac strip for the carpet was installed, and will have nail holes in the floor all along the floor where the tac strip was. Likewise, pulling up one corner of the carpet in a room and looking at the floor doesn't necessarily mean the floor is in good shape throughout the home. If it is an older home, there is a chance that at one time there may have been a floor furnace... that will have been ripped out and usually crappily covered up. Likewise, lord only knows what other catastrophes previous handymen have left for you spilled paint, burns, water marks, etc). Not to put a rain cloud over ya, but you could be opening one heck of a can of worms for yourself... just so you know....
2007-08-16 06:56:23 · answer #2 · answered by wer30snfun 3 · 0⤊ 0⤋
There is no reason to have to sand the floors if they are already finished and varnished.
Just pull the carpet up and see what they look like.
Probably someone who had the place before you just decided they would prefer carpeting to wood floors.
2007-08-16 06:13:06 · answer #3 · answered by llittle mama 6 · 0⤊ 0⤋
Depends on what shape the floors are in. If you do sand them, you will have to stain and seal them as well. If they look pretty good, sweep them and use a good cleaner/conditioner designed for wood floors. You can find these at Lowe's or Home Depot or any home improvement store.
2007-08-16 06:10:13 · answer #4 · answered by ? 6 · 1⤊ 0⤋
Depends how they look to you. If they are acceptable as is so be it. Most tool rentals will rent commercial floor sanders reasonably and they are not hard to use just sand with the grain. Lots of finishes are available from linseed oil to polyurethane and back explore and love your floor.
Good Luck
2007-08-16 06:11:16 · answer #5 · answered by arborsurgeon 4 · 0⤊ 0⤋
well that all depends on the condishion of the wood floor under neath if its rotted or varybadly staned replacing it might be ur best corse but if its in good condishion just alil polish may be all u need good luck
2007-08-16 06:18:15 · answer #6 · answered by silverlordanubis 2 · 0⤊ 0⤋
its not as simple as it sounds but if after removing carpet,floors are not damaged,first try cleaning with diluted windex,after sweeping of course.
2007-08-16 06:19:59 · answer #7 · answered by ira rose 1 · 0⤊ 0⤋
If you are attempting to do this yourself, I would suggest checking with your local Home Center for the right procedures or hiring a professional to do it for you. Some hardwood need special treatment and care.
2007-08-16 06:11:20 · answer #8 · answered by S. 1 · 0⤊ 1⤋