i know its in the solenoid switch but i dont know how to wire it since the instructions dont say
2007-08-16 03:34:35 · 4 answers · asked by Bretton C 1 in Cars & Transportation ➔ Car Makes ➔ Ford
First off are you sure it is not the bendix in the starter hanging up?
Next here are 3 links to the wiring depending on your engine model:
http://www.chevelles.com/techref/tt4b.gif
http://www.oldengine.org/unfaq/FordSolenoid.jpg
http://www.chevelles.com/techref/tt4a.gif
2007-08-16 03:59:14 · answer #1 · answered by cgriffin1972 6 · 0⤊ 0⤋
Look at the existing one - carefully mark the wires, and the new one goes in the same way.
If you can't figure it out - you can try looking online for a diagram, or get a manual for it at an auto parts store.
If you aren't mechanically inclined, you might want to let someone else do it for you so you don't destroy anything.
2007-08-16 03:41:59 · answer #2 · answered by Anonymous · 0⤊ 0⤋
Before you replace, make a note of how it was wired. Take a picture if you have too.
2007-08-16 03:40:55 · answer #3 · answered by Jody D 6 · 0⤊ 0⤋
The solenoid should have an "S" and "I" on it . If in doubt, guess. If wrong, it won't start. Bob H
2007-08-16 04:08:23 · answer #4 · answered by Bob H 7 · 0⤊ 1⤋