Can I use a single phase hobart mixer in a restaurant that has 3 phase power? Thanks?

Answer 1

Yes. Your three phase service can be used for single phase and three phase equipment.

Assuming the voltages are compatible, this should be easy work for a local electrician.

Answer 2

Yes. You can use a single phase in a place that have three phase but cannot use 3 phase in a place that have 1 phase. The different between 1 phase and 3 phase is 1 phase have 1 life supply + 1 Neutral + 1 Earth. Whereabouts 3 Phase have 3 life supply + 1 Neutral + 1 Earth.

To connect you mixer, choose a life phase, neutral and earth. The best is get your electrical guys or experienced people to do the job. Please remember that Electricity don't bite but KILLS. Good luck

Answer 3

Yes, just get the correct circuit run to the machine. It may hook up with 1 phase and a neutral, 110 V, or with 2 phases and no neutral, 230 V. The nameplate on the machine will indicate the correct voltage. Any qualified electrician can install the circuit for you.

Answer 4

of ousre u can use singlphse with three phase. u have to use 1 live wire means either of phase (red, blue or yellow) stirctly onephase only. and one neutral as potential diff between two phase is duble then diff between one phase and neutral. it means if ur supply is 120v then it will be 240v betwen two phase. so use one phase with neautral. Dont forget to give earthing connection. its imp.

Answer 5

I believe that you just hook it up to a single phase out of the three but check with your electrician.

Answer 6

Yes. Your machine probably runs on 120VAC, which would be available in a 3-phase building.

Answer 7

yes you can, as long as you plug your welder to the same voltage in any two wire of the three phase system.

Answer 8

Yes you can, just select two of them.