How do you program a key remote for a 1995 Ford Taurus?

Answer 1

To program (or reprogram) keyless entry remote transmitters (15k601) into the electronic door lock control processor, perform the following steps:

NOTE: The electronic door lock control processor erases all previous keyless entry remote transmitters from memory when the keyless entry remote transmitters are programmed or reprogrammed. The electronic door lock control processor can store up to four keyless entry remote transmitters in memory.



Turn ignition switch (11572) to RUN or ACC position and momentarily short the two terminals of the program connector (C4) (a two-pin connector taped to the wire assembly can be reached by removing the left hand luggage trim panel). All doors should lock then unlock. Remove shorting pin.
Press any button on keyless entry remote transmitters. All doors should lock then unlock, to verify that keyless entry remote transmitters have been programmed. NOTE: If door locks do not respond, press button again (up to three times maximum with the same keyless entry remote transmitter). If door locks still fail to respond, go to Pinpoint Test B.
Turn ignition switch OFF. All doors should lock then unlock.
Check operation.

I assumed that you are talking about remote keyless entry key FOBs since the 95 Taurus didn't have PATS ignition keys yet, this should help.

Answer 2

Yes you can self program your key fob to your 1995 Ford Taurus. The self programming instructions are listed below. If you ever lose, break, damage, or just need an extra key fob we've got you covered. We sell Factory OEM key fobs up to 80% off dealer prices. We also have free self programming instructions for alot of different vehicles.

Visit us at: http://www.keylessentryremotefob.com/

1. Turn ignition to RUN or ACC.

2. Momentarily jump pins in programming connector located in LR quarter panel area (Connector will not be plugged into anything, it will have two pins inside it, if you have to unlug it you have the WRONG one. Not all vehicles are set up from factory for keyless remotes) All doors will lock then unlock to confirm programming mode.

3. Press any button on first keyless remote. Door locks will cycle to confirm programming.

4. If programming a second keyless remote, press any button on second keyless remote.
Door locks will cycle to confirm programming.

5. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.