nissan xterra programming?

Question

i followed the steps of entering and removing the key from the cylinder. the hazards lights flash on the sixth time and when i finish the process the remote does not work though, what can i do or what am i doing wrong?

Answer 1

After six in outs T/S Light flash twice turn the ingnition key to on posistion just before start crank. then push any button on that remote turnsignals should flash twice if they do not either your remote is defective or is not the same frequency. At nissan dealers we have a digital tester we place a remote on and push the buttons and warch it brodcast. You did good now buy a good remote. Good luck

Answer 2

1. Close and lock all doors with the driver’s side power lock/unlock switch. 2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. ( Withdraw key completely from ignition cylinder each time ) . If this procedure is performed too fast, system will not enter programming mode. 3. Insert key into the ignition cylinder and turn to the ACC position. 4. Within 5 seconds, push ANY button on the keyless remote. Your Hazard Lamps should flash. ( Do not press the button more than one time in the above step). If the button is pressed more than one time, the programming procedure will not be successful. 5. If there are any remaining remotes (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each keyless remote (including any existing keyless remotes). 6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.