My speakers won't work. I've placed them in the front and back ports. it only works in the front. Only one works and but its way too low to even hear a good sound. I've went to the control panel to get it higher but the sounds on both speakers on on the maximum capacity. Can anyone please help me out?
2007-06-23 15:27:53 · 3 answers · asked by Anonymous in Consumer Electronics ➔ Home Theater
Whatever's powering the speaking might not be powerful enough. Or your speakers just broke, or you speaker wires need to be checked.
2007-06-23 19:41:57 · answer #1 · answered by curiousmike 3 · 1⤊ 0⤋
Switch the speakers around. Is the same speaker the one that still has no sound? If yes, speaker problem, if no, then it is receiver problem.
Is the "balance" knob in the middle?
What is the input port? Does it match the source? (example: turntable in PHONO input, Cassette in AUX, etc.)
There are so many things that could be wrong (say, receiver set in "monitor" mode by accident), that is tough to help you here.
2007-06-23 19:54:58 · answer #2 · answered by TV guy 7 · 0⤊ 0⤋
Hi there,
Please check the impedence of your speakers(the ohms). You cannot connect multple ohm speaker to one reciever, they all have to be the same. If you go to the reciever's settings then you can change the ohms to match your speakers. Hoping that you have got + and - correct, then make sure that they are connected to the correct output speaker lines of your reciever. If you have base speaker then you'll need to connect them to front L and R of your reciever. If they are rear (treble) speaker then you'll need to connect them to Rear Surruond L and R outputs of you reciever. If you have a center speaker then you'll need to connect it to the center speaker output of your receiver. And if you have a subwoofer, connect it to the subwoofer out of your reciever.
Hope this helps and good luck!
2007-06-24 05:44:00 · answer #3 · answered by geso 4 · 0⤊ 0⤋