English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Bathtub faucet vibrates and make noise when turn it on

2007-06-21 17:45:32 · 6 answers · asked by pradit s 1 in Home & Garden Maintenance & Repairs

6 answers

If it is one of the older style fawcets that use washers, I'm guessing the screw that holds the washer is loose or maybe even missing. When you open the valve just the right amount the washer can oscilate from the water passing around it and make a amazingly loud, annoying noise. You'll need to shut off the water, remove the fawcet stem and see if that is the case. Its is usually an easy repair.

2007-06-21 17:58:33 · answer #1 · answered by Flying Dragon 7 · 0 0

If it is from the hot water side of the faucet (if you have a three handle faucet. Try turning the temp down on you water heater. Some times this will help. If not you will need to replace the washers.

2007-06-22 02:05:57 · answer #2 · answered by Drain Man 3 · 0 0

the washers are loose in the faucet just turn off the water and remove the valve stems on the end of these are where the washers are attached tighten them up this will stop your vibrating

2007-06-22 11:34:01 · answer #3 · answered by john v 3 · 0 0

they are directly plumbed,ie no expansion of water,cure a foot of pipe above the tee to valves,must have access

2007-06-22 17:06:30 · answer #4 · answered by tom the plumber 3 · 0 0

Change the washers.

2007-06-22 00:54:30 · answer #5 · answered by Pablo 6 · 0 0

youre pipes are loose in the wall!

2007-06-22 00:52:44 · answer #6 · answered by Turkish 3 · 0 0

fedest.com, questions and answers