how do you disconnect the seatbelt buzzer in 2006 ford f150?

Answer 1

The following is an excerpt from your owners manual:
************COPY>>>>>>>>>>>>
Read Steps 1 - 4 thoroughly before proceeding with the
deactivation/activation programming procedure.
The driver and front passenger BeltMinder features can be
deactivated/activated by performing the following procedure:
Before following the procedure, make sure that:
• The parking brake is set
• The gearshift is in P (Park) (automatic transmission)
• The ignition switch is in the OFF position
• The driver and front passenger safety belts are unbuckled
While the design allows you to deactivate your BeltMinder, this
system is designed to improve your chances of being safely
belted and surviving an accident. We recommend you leave the
BeltMinder system activated for yourself and others who may use the
vehicle. To reduce the risk of injury, do not deactivate/activate the
BeltMinder feature while driving the vehicle.
1. Turn the ignition switch to the RUN (or ON) position. (DO NOT
START THE ENGINE)
2. Wait until the safety belt warning light turns off. (Approximately 1
minute)
• Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.
3. For the seating position being disabled, buckle then unbuckle the safety
belt 9 times, ending in the unbuckled state. (Step 3 must be completed
within 50 seconds after the safety belt warning light turns off.)
• After Step 3, the restraint system warning light (airbag light) will be
turned on for three seconds.
4. Within 10 seconds of the light turning on, buckle then unbuckle the
safety belt.
• This will disable the BeltMinder feature for that seating position if it
is currently enabled. As confirmation, the restraint system warning
light will flash 4 times per second for 3 seconds.
• This will enable the BeltMinder feature for that seating position if it
is currently disabled. As confirmation, the restraint system warning
light will flash 4 times per second for 3 seconds, followed by 3
seconds with the light off, then followed by the restraint system
warning light flashing 4 times per second for 3 seconds again.
2006 F-150 (f12)
Owners Guide (post-2002-fmt)
USA (fus)
Seating and Safety Restraints
137

**************END COPY<<<<<<<<<<<<<<<

To download your entire manual click here:
http://www.motorcraftservice.com/pubs/content/~WO6F12/~MUS~LEN/36/06f12og4e.pdf

I HIGHLY recommend that you download & read the entire text from pages 135-137 PLEASE (before you deactivate!)

Answer 2

I am going to assume that you want to disconnect the seat-belt buzzer because you don't want to drive with a seat belt. Let me say that it is there to save your life, so that like disconnecting a buzzer to let you know your car door is not closed.
===
But if the buzzer is broken and constantly on, you can just follow the noise and find the buzzer. Then just find any wires and cut them.

Answer 3

Get out your owners manual. In it is the procedure..after four pages of disclaimer to satisfy the lawyers. It will tell you the buckle and unbuckle procedure.

Answer 4

there is a electrical connection at the bottom of the seat belt where it bolts to the floor . just unplug it . leave it like that incase you have to sell it , then put it together again.

Answer 5

there should be a wire conection under driver seat unhook that.

Answer 6

you can stop the alarm by buckling up

Answer 7

annoying as it is - WEAR THE DAM* THING!